Hi I have completed all the steps but, when it says it's only 75% complete. It is saying the the subnet mask for the PC is not complete but the laptop is. I'm not sure what is is asking for because the steps do not tell me to do anything with the sub...
Forum Posts
Hello!I have a very important task to do. I did everything, but for some reason it doesn't work.I need your help! I will be grateful to you.Task:LTE interface IP: 87.110.156.22 MASK 255.255.252.0 Default GATEWAY: 87.110.156.1 DNS: 8.8.8.8 ...
I'll preface this by saying that I am in the process of replacing all of the Small Business switches that I inherited with devices that use IOS.I am currently migrating to a new ISP. This requires all new subnets and a new vlan scheme. I am in the pr...
Resolved! err-disable state
there is any reasons for switch port sfp module going to err-disable state
Hello, I do a lot of work with SG300/350 and the CBS350 with different number of ports. I would like to know if I can back up the running config from say a CBS350 8 port to a CBS350 48 port for example of even to any of the SG300/350 switches and if ...
Resolved! VLAN Interface on layer 2 switch
Hey ! So I have configured an eve-ng lab.I have a cloud which what connects me to the bridge (My network).To the bridge I have connected a router and a switch (Cisco IOL L3 and L2).My router automatically received an IP address.On the switch I have c...
I've got a WS-C3650-12X48UQ running IOS-XE 16.12.08 software. This model has 36 ports of Gig and 12 ports of mGig. The swtich is uplinked to a cable modem which has a 2.5G mGig port. I've got an absolutely bizarre issue I'm hitting that feels li...
Hi allI do a complete overhaul of my network and storage solution. I want to connect my two new NAS via 10G SFP to my future switch. I though about using a CBS250-48P-4X for that as it has four SFP connections. My question is as follows: The SFP conn...
I'm believe I know the answer, but I just wanted to get verification. If I have a Cisco switch where I have one of the ports configured as an access port on VLAN 10, then I can connect an unmanaged switch to that access port and connect endpoints to ...
Is there a possibility to enable a periodic reauthentication of rejected 802.1x/MAB Clients? When I configure authentication timer reauthenticate <time> or authentication timer reauthenticate server on an interface I see the Session Timeout only for...
Resolved! Use of secondary IP on Vlan interface
Hi Everyone,Need to know how the use of secondary ip address under vlan interface is for extension of subnets.If someone can please explain this with example?thanksMahesh
Resolved! Can't access Web UI on Catalyst 9300L
Hello,I'm currently trying to access the Web UI of my Catalyst 9300L switches. I can access the switches via SSH but not via web.It simply won't load the site. Looks like port 80/443 is not open... Do I need to set some other settings to get it runni...
I want to set both new and old IOS image in boot path variable on CISCO catalyst 2960/3750/9300/3850 series switches.If i set boot path as below it can work or not?Just have doubt about if new image code broke during upgradation then switch automatic...
Hello Professionals,I used to have C2960X series PoE switch, and it connected to Aironet 2802E AP with Full power provided.However, after I replace siwtch to C9200-24P (PoE), switch does NOT provide full power to my 2802E AP.Even I setup manually to ...
