Switching

Hello, I have the following issue with two switches connected through a 100Base-FX link. On one side there is a WS-C2950C-24 (fixed configuration switch with two native 100Base-FX ports) and on the other side there is a WS-C2960-24TC-L using a 100Ba...

We have set up all our Switches on a VTP domain but I want to be able to add new switches and to be able to use password. How can I go about doing this bearing in mind that I already have about 6 switches that are not using password? I want these to ...

we hv a network of 700 retailer connecting with router 2500 series now as it goes overload (CPU) user are auable to connect to the servers.plz suggest a better router that can afford shuch load n udp broadcast frequently. you may suggest out of sale ...

Hi,I was trying to configure NAT between two VLANs on SUP720 based 6509 switch? Is there any constraints or is it straight forward?RegardsKerins

I used the Cisco Feature Navigator to find a Image for a cat 3750 that has SSH. it said to use 122-25.SEE2. So I downloaded c3750-ipservices-mz.122-25.SEE2. but the example configurations are not working for this switchs. Any suggestions?

Hello,2650XM crashing without any reason. I think it might be a memory problem. Is there any way to test the memory? Or should i test anything else?

hii....Is bootrom means EPROM & NVRAM means SRAM in cisco 8541 CSR-RP card.can ony tell me or any url link to find out the location of memory in card.ThanxManoj Jain

Good evening all,Have two 3750-12S, stacked. After configuring our 10th etherchannel group, all switch ports went down. Did not catch any messages pointing to issue.Very basic config for inter-vlan routing. One port from each switch in stack are gr...

Hello All,Need assistance, am trying to configure etherchannel between a Cisco3725 and Cisco Catalyst 3550. Can't get it working with my existing config below. Please help.Physical Connection3725 F0/0 ---> 3550 F0/13725 F0/1 ---> 3550 F0/2===== ROUTE...

Is there anything special about Cisco 3662-AC-CO?I'm use to 3640s and 26xxs, is there anything 3662-AC-COs will / will not do compared to these?

This is new to me. I am doing a basic HP server setup, 2 connections plug to 2 different switches. Configure Load Balance and Failover. Is that possible?What should i do on HP server teaming and Switch Catalyst 4000 (EtherChannel in order to perform ...

Hi,Could anyone recommend a router for me? I need the samllest router possible (1u) that has or has support for 3 fast ethernet interfaces and support for vlan routing.thanks!