Switching

Could anyone help me to configure the VSS between 2 cisco 6500 switcehs.Thanks

I have a 6509 with many VLANs and a seperate DHCP server to provide addresses.  I need to create an additional VLAN (VLAN 20) and I would like to use the 6509 as the DHCP Server for the new VLAN. I know to set up:ip dhcp excluded-address 20.20.20.1 2...

Hi Forums,i am new on the CISCO IOS.. I am configuring my cisco 1841 with hwic-1t serial port but i have problems with nat for my LAN.The router "pings" all IP addresses but all LAN doesn't navigate. Where is my mistake ?interface Loopback0 descripti...

I added an image of a table present in the "CCNP Official Guide" by David Hucaby.Is it possible that the author reports so many fields with wrong lenghts?For example, protocol(16) or ICMP type(4).Or have I lost some concepts?

One of my main routers is getting a bunch of buffer misses, resulting in packet drops.  I have pasted output below:Genoa-C3845-Rtr#  sh buffBuffer elements:     1117 in free list (1119 max allowed)     445357378 hits, 0 misses, 619 createdPublic buff...

Hi,I have a Cisco 3560 layer 3 switch where I have 5 VLAN's. I have edge switches placed for each vlan for connecting the computers/laptops. A DHCP server in one of the vlan servs a dynamic IP if a user connects a laptop/computer to one of the port i...

How do I tell which Catalyst 4506 chassis I have, I need to upgrade it, and only have remote access. show version etc., doesn't show whether it is an E type or not.

I have a 3750 switch that bridges our corporate office to our Ethernet Network. 1- The port that bridges corporate office to the Ethernet Network is a L3 interface.2- The port went into err-disable state, their was no recovery so the interface stayed...

HelloI have an etherchannel trunk (3750's) between my two floors.  I have since added another run and would like to add that port to the trunk, what is the correct way to do that?  Add the trunk configuration to the interface before adding it to the ...

hi,Plz. send the config. How to bind IP address with MAC.

Hello,How is it possible to detect/locate/discover a duplicate IP address in a network (LAN)?I have recently found in one of my LAN (remote site) that a switch has the same address as the virtual VRRP (adress of my two WAN devices). I had often many ...

I'm planning to run multiarea ospf on cisco 3750 switch as a redundant path. I'm using 6500 switch for my primary path. Both 6500 and 3750 do ABR and ASBR.Has any one experience technical problem running multi area ospf on 3750 switch? I want to put ...

I have a 3560 series switch and was wondering about powering the unit 12VDC.  I will be mounting this in a solar site for canopy wireless Internet.  I do not have a inverter for AC power at this time.  I would like to keep this site DC.  The male por...