Switching

C2950 Boot Loader (C2950-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1)Compiled Mon 22-Jul-02 17:18 by antoninoWS-C2950-24 starting...Base ethernet MAC Address: 00:17:5a:1c:77:40Xmodem file system is available.Initializing Flash...flashfs[0]: ...

Hi,does anybody know which wavelength the WS-X4124-FX-MT uses?We want to use fast ethernet mediaconverters at the other end of the connections which uses 850nm and 1300nm.Many thanks,Thorsten Steffen

What is the need for cisco-vtp-mib for router devices ?

Port mode modified in another CLI session, ignoring [no] switchport cmdI can't find the meaning of this error message anywhere.It occurs when doing the following:Router#conf tEnter configuration commands, one per line. End with CNTL/Z.Router(config)...

Does Cisco has a tool to automatically document current network including router, switchs, firewall and their connected interfaces? If you know of any tool on the market please advice. Thanks

What's todays look on Medium to Small branch office design? Do you stack multiple switches or buy lets say a 4500? I'm looking for Pros and Cons. And if you stack how do you tie in SX,SC fiber to the Access layer?

I need create class-map in the Cisco Switch 2950, but I dont can create it. I upgrade the IOS. The Ios running in the Switch is the following:IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA13, RELEASE SOFTWARE (fc2)BOOT path-list: flash:...

Can anyone give me any insight into this error?:xxx>sho ip traffic | inc encapsulation Drop: 36177634 encapsulation failed, 109 unresolved, 0 no adjacencyThis error is increasing...

Hi,I have some very basic doubt regarding switch specifications / performance paramaters.In performance capacity of switch specification • - it is mentioned : 160-Gbps switching fabric capacity : what does this mean?How it is mentioned on chasis sw...

I would like to set up a fault-tolerant configuration where 2 routers with 2 FE ports connect to 2 L2 switches with trunk ports.I am thinking if the following configuration would work on the routers :int vlan 30ip address 10.10.30.1 255.255.255.0int ...

We have a packet loss issue when pinging from a switch to another switch. We believe this packet loss issue may be the cause of a customer complaint.In doing some testing, I see the packet loss issue, but as soon as I enable debugging, it goes away....