Switching

I have configured a Squid3 proxy server on Debian using WCCP to a Cisco 2821 router (via GRE tunnel). Regular HTTP traffic works just fine. Anytime I try to connect to HTTPS, it times out. I've compiled Squid with --enable-ssl. The squid configura...

Hi, I need pointers in using one of my Cisco router as an inter VLAN router routing between VLAN's on HP Procurve Switch. Any documentation would really help

Dear Experts,I would like know little physcis here of 6509-E, Here in one of the data centers we have incoming voltage 220 vlots which is fine no issues, but the electricity is coming via UPS and the amps which are coming is 32AMP and 6509-E required...

HiCan ssh be applied on Cisco 2960. Are configuration commands same similar to Router.

It would be quite helpful to me if u suggest how to select a IOS for upgradation for the below scenarios.Currently I have 4 switches to upgrade for ssh feature, below are the existing IOS images.i.e.1.c3560-ipbase-mz.122-25.SEB4(Model:WS-C3560-48PS)2...

Hi, anyone knows if exists any limitation of using sctp with ip vrf forwarding?Thank you.Best regards,

Found the answer :-It was part of the message in the Banner !!Dont know why it was modified though.===============================Hi,I just changed my enable password, and now I keep getting a warning whan I login.I have reloaded several times, and ...

I have a situation where 100+ sites are connected together via MPLS (BGP), with some of the larger sites also being connected with high speed WAN connections (100Mbps) that handle the majority of the traffic between these larger sites. Each of these...

HiGuru's who have implemented Wireless LAN Controller, any recommendation or watchouts based on experience.

When trying to configure "mls qos trust dscp" on the Gig-interfaces on a Sup720-10G in virtual mode I get the following error message:" HWIF-QOS: QoS configs are not allowed on VSL Portgroup."As far as I know only the 10G-int can be part of the VSL. ...

Hi,I m trying to connect 3com switch to cisco switch 3560 with sfp (Fiber). But interfaces not cumming up, can u pls suggest me if i need to use any converter in between this one.Regards,Sunish

Is it ever possible to assign loopback addresses on Cisco Switches. Or are they only configurable on routers?ThanksKevin

Hi, kindly guide me will I be able to achive the application fail over and load balancing running on the linux servers using the Cisco load balancer 7604.thanks in adavance,Sanjeev.