Switching

Hi,Configured VSS successfully on 10 GE port, after that trying to configure SVI vlan interface but interface state in down . 1. configure vlan 30 in vlan database2. configre interface vlan 30 ip add x.x.x.x x.x.x.xanything else i am missing . pl...

i want to know what's better to work core switch 3560G-TS-S or switch 2960G-TC-Lthanks

I'm trying to configure a router but ISP provided address doesn't match up. range: 10.30.153.1 to 128 subnet mask: 255.255.255.0Gateway: 10.23.99.1If I use any IP from the range above on Windows XP, I can connect to the internet. The ISP said it shou...

Hello i just have small Questions to you guys when can we use HSRP in L2 switches and why for ?Thanks a lot

Hi,I am trying to work out how to do a regex to match an IP and also a specific port.This is for say a show ip nat translations where I want to see just the translations for a particular ip and port.I've been trying to work it out for ages but just c...

Hi,If we need to connect Cisco IP phone and the a PC connected to this IP Phone, with Voice VLAN as 10, and Workstation VLAN as 20.Here is the configuration:int fa1/1switchport access vlan 20 ( workstation )switchport mode dyna desirswitchport voice...

I created a new thread because the other one has sort of been closed by the fact that I marked some answers as having resolved the issue (red check mark), so i think no one is going to open the thread.Jon or anyone else, of course: Here is the final ...

Hello : My customer has 4 Cat4506-E with Sup6-Einstalled a month back . All 4 switches are haveing memory leak error msgs with"HTTP CP " process . And my my customer had to reboot the chassis to bring up theservice . Cutomer uses 12.2(44)SG1 IOS on ...

Hello, I'm trying to create an access-list to use with policy-based routing. When I create the access list it morphs into something else and I'm not sure exactly why. Here is what I type from the command line:access-list extended PBR deny ip host 1...

two wireless link works fine without etherchannel , but i configure etherchanel and works slow and etherchannel show this:Po2(SD) PAgP Fa0/20(I) Fa0/21(I)Port state = Port-channel Ag-Not-Inusethe link is like that:sw3560 - 2 br1400 ---- 2 br1...

Hello,I am studing for SNRS and for configuring MAC Spoofing I found these commands:port security max_mac_count [1..132]port security action [shutdown/trap]But, before that I learnen about Cam Table Overflow mittigation with these commands:switchport...

Hello,We have a blade switch CBS30X0-LANBASE-M that won't sync to NTP nor authenticate to ACS.SW1#show ntp associations detail 172.23.218.187 configured, insane, invalid, unsynced, stratum 16ref ID 0.0.0.0, time 00000000.00000000 (00:00:00.000 GMT Mo...