Switching

I have a VACL set up to forward/capture certain VLAN traffic to an ART applaicne. However, when I attepmt tp limit or exclude Veritas traffic, it still allows all traffic through. What am I doing wrong?vlan access-map VACL_MAP 10 match ip address V...

I have a router with the following interfaces : interface FastEthernet6/0 description <<137.55.67.0 Subnet>> ip address 137.55.67.1 255.255.255.0 ip access-group 100 out duplex auto speed auto ! interface FastEthernet6/1 description <<137.55.68.0 Sub...

Hi All,I am at strange.We have one primary location as DC at Odensewe have one Core switch (4507) here and all servers directly connected to this one.One MPLS line with 2 MB speed connected to this switch only.we have many remote locations and those ...

Can someone please tell me which antenna on a WAP4410N is Send and which is Receive?

Hi,Last month, we had nbar ran on our devices to check the traffic , majority were found to be http with some voice.one output was strange..Se0/0/0 10.0.10.34 Fa1/0 10.35.6.75 06 0000 0000 1 the 0000's on last columns are th...

Can an ethernet type connection be set up between lan interfaces on a 3725 and a 2620XMrouters- If so, is there any requirements, like IOS version, card type and so on

Hi all, We are having some dist switches installed for the access layer, we paln to put in HSRP, my question is, should I leave the default timers of 2 and 10, or shoudl i make them less? OR should I use GLBP ?Also, I want to have all the clients on ...

hi allI need to create management vlan with ip 11.14.10/24 in the catalayst 6500 seris switchthe gate way ip to be used for new vlan willbe 11.14.10.1could you please any one tell me how to configure with commads and please share me the documnetalos ...

HiI got a Cisco router, it is also the DHCP server of my network the detail are below.For some reason the server randomly stops serving IPs to workstations, even a repair conection does not work. Some computers have a valid IP but it does not get ren...

Hi, I'd like to mark incoming UDP packets with DSCP values on a 6509 with Sup720 3BXL. Incomming interface is a WS-X6748-GE-TX What I did is---------mls qosclass-map match-any UDPKRAM match access-group 100policy-map UDPKRAM_AF21 class UDPKRAM se...

Hi All,I need the operational and technical difference between the following products.1. WS-X6148-GE-TX2. WS-X6548-GE-TX3. WS-X6748-GE-TXThank you,

So this is probably a very easy question and I've done some searching on the net but can't seem to find an answer. Does anyone know what the asterisks * means when in front of any given log entry? I noticed that some log entries have them, yet some d...