Buy or Renew
Buy or Renew

Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

Resolved! Time of day Routing

Hi all,I have an interesting scenario. I want to allow any session goign thru router/pix 515 for a specific period of time lets say 08.00-16.00.How can I achieve it?

ACLs to allow only printing between VLANs

On a 4507 switch, I have several VLANs defined. I'm defining ACLs for these and have run into a problem allowing printing between two VLANs.VLAN 2 is defined for public devices and VLAN 6 for staff. Public devices have no need to interact with staf...

scdladmin by • Level 1
  • 11461 Views
  • 6 replies
  • 0 Helpful votes

Resolved! boot system and config register commands

HI every body!If we use " config register" and " boot system" command, which one takes precedence over the other? for example config register specify the different location for ios to load and boot system specify different location for ios to load....

sarahr202 by • Level 5
  • 1107 Views
  • 4 replies
  • 0 Helpful votes

sonet and pstn'co

Hi every body!I have few questions about sonet which performs layer 1 function for atm( a layer 2 protocol).1)Does sonet connect central offices together in usa?2)How does the pstn network in usa connect to pstn in a foreign country?thanks a lot!

sarahr202 by • Level 5
  • 641 Views
  • 2 replies
  • 0 Helpful votes

Resolved! how does router connect to ATM switch?

Hi every body!In frame relay, router connects to frame relay switch using T1 line. The router may have integrated csu/dsu on T1 card or csu/dsu can be stand alone unit .1)In ATM network, does router have the intergrated cs/dsu on ATM interface card o...

sarahr202 by • Level 5
  • 1268 Views
  • 1 replies
  • 0 Helpful votes

No Netflow, Catalyst 3750?

I am currently working on a project that has 30 plus Catalyst 3750G switches in its network solution, the 3750 is a great switch, however one problem the 3750 does not appear to support Netflow! which is a bit of a problem, will there be a software u...

Help with "switchport trunk allowed vlan"

Hi,I have a Cisco ASA 5520 which has a 3750 trunked off it (see diagram, ingore the ASA standby).Everything is working, but I can see the follwoing vlans are allowed through the trunk - 3,4,6,7,9,10,300, but vlan 2 isn't in this allow list and it sti...

whiteford by • Level 1
  • 2150 Views
  • 21 replies
  • 0 Helpful votes

Resolved! Static DHCP bindings

Hi,I'm very new to Cisco, so bear with me. I am setting up an 1812 and I'm having trouble using DHCP to distribute static addresses. I have had quite a bit of experience doing this with other routers and thought I had it right. Using SDM, I define...

aldboccio by • Level 1
  • 16114 Views
  • 7 replies
  • 0 Helpful votes

Changing MSTP Config

I am relatively new to MSTP, and before I recommend using it for a network I am looking at, I would like a little clarification.Within a region, I have seen it documented that the region and version need to match, ot the switches will consider themse...

Resolved! Blocking address range on my router

Hi,I would like to block following address range on my router ext int.71.64.0.0 - 71.79.255.255.Will the mask be 0.15.255.255.Should I follow access-list 101 deny ip 71.64.0.0 0.15.255.255 any.And add access group 101 to int.Correct if I am wrong mas...

sushil by • Level 1
  • 420 Views
  • 1 replies
  • 0 Helpful votes

Resolved! Interview question

Hi,I have attended an interview they asked me one simple question but i have some dought on my answer.question: A router with single interface connected to L2 switch, we want 5 Vlanswhere do we create the Vlans?where to add the route for intervlan co...

Load more