Switching

Discuss Catalyst brand switches with peers and experts.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|

Labels

Forum Posts

We have 6500 switch running IOS s72033-adventerprisek9_wan-mz.122-18.SXF3.binMany servers are connected to this switch. When i use wireshark to sniff traffic on ourwindows DFS server connected to this switch, i see traffic for entire VLAN on wireshar...

altaf007 by Level 1
  • 1191 Views
  • 6 replies
  • 0 Helpful votes

I am required do a lan design for a 500 phone on a non converged environment.1) There will be 100 phone on each floor.The phones will be using g729 as preferred codec.2) Fibre will be used uplink these switches.3)A 10mb WAN connected will be used to ...

I have a site trying to do the following: service-policy output voip and receives the following error: priority command is not supported in output direction for this interface I found that the WS-X6704-10GE doesn't support "priority" queueing. So, wh...

rlortiz by Level 1
  • 996 Views
  • 4 replies
  • 0 Helpful votes

Greetings all,We're a small company with 50 people. We have a lot of consultants and partners working on our site. The problem we have is that these people connect their laptop and have access to our internal net. I tried vlan and put them in DMZ but...

Need help from folks with expertise in Solarwinds Network Performance MonitorI am running Solarwinds NPM versino 8.1on windows 2003 Enterprise Server Service Pack 2. The solarwinds can monitor my network devices and firewallsjust fine, with one exce...

cisco24x7 by Level 6
  • 545 Views
  • 1 replies
  • 0 Helpful votes

I've just recently configured etherchannel and have noticed in my logs a lot of host flapping. Can you tell me why it's flapping and how to resolve it?Attached is the "show log" and configuration on the switch. Any assistance would be greatly appreic...

Hello, I have an existing customer with a single T-1 Internet connection terminated in a Cisco 1700 router. THey are going to a 2x T-1 connection, future upgrade to 3x T-1, and are considering a new router, or a carrier-managed router (2800) with an...

kpisacich by Level 1
  • 492 Views
  • 3 replies
  • 0 Helpful votes

I understand the command. But is there a way to make the time so it doesnt take a minute to refresh to its neighbors?R7(config)#do sho ip pim rp mappPIM Group-to-RP MappingsThis system is an RP-mapping agent (Loopback1)Group(s) 224.0.0.0/4 RP 103.10...

mikegrous by Level 3
  • 888 Views
  • 6 replies
  • 0 Helpful votes

Hi,According to the following:http://www.cisco.com/en/US/prod/collateral/iosswrel/ps6537/ps6586/ps6642/prod_white_paper0900aecd804fa16a.htmlin order to help tighten a CoPP Policy:"...Step 3. Review Identified Packets and Begin to Filter Access to the...