Switching

HiI want to see where a pix firewall will send packets destined for ip 10.51.3.2, how can I do this on a pix firewall? I tried "show ip route" but it doesn't work.ThanksDan

Hello,I am looking for a little advice on a network design I will soon be implementing. Currently we have a home office that has 20 employees. In the home office we have an internal lan that has a lan server(dhcp,file server, print server, active d...

I have the task of migrating a Network using public IP space of 199.248.x.x to private IP space 10.248.x.x. The public IP space is not currently allowed to the public internet but it is not best practice and there are security concerns. I have been h...

Hello,I want to configure 2 private vlans between my firewall-core-access switch.The setup is:firewall - trunk to coreSW - trunk to accessSWThe firewall is the L3 device for 2 new VLANs.On the trunk between the FW and the core are multiple VLANs conf...

Is this true?If you do not have BPDu Guard configured on a PortFast-enabled port that is receiving configuration BPDUs. the configurationBPOUs are processed by the switch and eventually the port might be shut down to prevent a loop However, because d...

hi i have a PoE 3560 Switch and another device working on PoE. when i plugged that to POE switch it is not going to work either switch POE is off or on.IOS is 12.2 ipbase. Is IOS be the Issue ?kindly share ur experince if anyone face that also

I have a catalyst 2960 and its connected to a redundant power supply. I rebooted the catalyst and the switch is now running primarily off the rps instead of the house current. Is there a configurable command to change that to house current or do I h...

In our our company we have many cisco products among that the 3550 switches have problem on power supply failure,ILP controller error and address bus test filled error and also they are out of warranty so we need to have vender specific training to ...

The matrix in the RPS2300 documentation states that you need two 1150W power supplies in order to be able to support two C3750-E switches.I understand that if you are using POE on the switches. If you aren't doing POE and only have a 265W power supp...

3750 runs low memory too often. The current memory is 128MB. Switch almost fully populated with ip phones/PCs. Is this an IOS bug? Running IOS is C3750-IPSERVICES-M), Version 12.2(25)SEE3

Hi guys,I am missing something here, need your help/advise on this.From my LAN router I can do the trace route to my esrver located in another site. However from the same router, I am not able to do the source based trace route from one of its interf...

Is there any CLI command by which I can monitor/view the traffic flowing through Cat6500.