Switching

I was configuring a Nexus 5020 and came across a few commands that I can't find what they do.logging distributelogging commitntp distributentp commitThey seem like important command that I should have under logging and NTP. Any help one this would b...

Hi, I have a doubt with my router 2801,nobody arrive at night in the office, so I think put the router in any action like overwintering, but I was reading and I didn't see any command to do this.Some Suggestion?thanks a lot

Hi folks - I think I posted awhile ago about having trouble loading an IOS image into my 2610's Flash.Now I've come across the email from the friend who sold me the file, and he flat-out said, "it is too large to load in the flash, so you have to boo...

Ok, right now my company's multicast network is a mess and is in severe need of a redesign/management. I'm wondering what the best way to setup this network would be with the equipment that I have or buying the minimum amount of extra equipment. Cu...

Hi Experts,I want to understand how multicast egress replication works on catalyst 6500. Say, the ingress module wants to send a mcast packet to six egress modules. The question I have is that - if the Crossbar Switching Fabric is able to replicate t...

Hi,I need to power down, move, and bring back on line a 6509 with one sup720. Other than making sure the config is saved, is there anything else (bootup related) that I should be aware of or perform before the move show ver shows his switch has bee...

hi,a Cisco 3560 switch (WS-C3560-24PS-S) has following scalability feautes Throughput : 6.6 MppsBackplane Capacity : 8.8 GbpsCan anyone explain this ?thank in advance.regardsRajib

Hi, I need some help configuring a 1811 for routing 2 networks and IPS. and a ASA 5505 for Firewall, content filtering and vpn.Right now I have them setup on a test lan. I have the 5505 and content filtering working , but I am having problems with ro...

We have an issue with Ghost server getting over vlans (layer 2). This is using Mulicast, Directed Broadcast and unicast. There are no access lists or any other security hurdles between them. It works when it's on the same vlan (obviously). Also, ...

I'm trying to mapp out a network and I have a catalyst switch I need to access. The only information I have is that it is not ip addressed. It is accessed through port 49 VL220 I have the password but don't know how to interface with it with out a ...

With the following:interface Loopback0 ip address 192.168.199.1 255.255.255.0interface Vlan1 description $ETH-SW-LAUNCH$$INTF-INFO-HWIC 4ESW$$ES_LAN$$FW_INSIDE$ ip address 10.0.0.254 255.255.255.0interface Virtual-Template1 type tunnel tunnel mode i...