Switching

Does the Cisco web browser user interface work on a setup with two 6509 with VSS? I am told it does not support it.Mike

on our lan we want to use vrf-lite to isolate 2 vlan from the others but they have to interact with the vrf WAN for exemple so there might be route leakingJust a question about the confwhat's the difference between this config ip vrf wan rd 1:1 rout...

Hi all,I am experiencing a problem on a single machine on our network. For some unexplained reason this machine unpredictable goes offline and the only way it appears to bring it back is to do a shut/no shut on the port.Any ideas how I can troublesho...

Hello,If you have a lot of switch port access collisions (2950 switch) does this mean you have speed and duplex mismatch? Thanks for your help.-chie

Hi, I can see next information:Cat 5e: Currently defined in TIA/EIA-568-B. Provides performance of up to 100 MHz, and is frequently used for both 100 Mbit/s and Gigabit Ethernet networks. Cat 6: Currently defined in TIA/EIA-568-B. Provides performanc...

Hi AllI would like to know when LAN switches 3750ME and 3550 start to support BGP neighbor ttl-security feature. Thank you, Susanne

Hi all, As there is a timer for the arp table on a router, if I was to change the ip address on the inside host but the router still had the old arp entry on there, what would happen? if it could not see the address in the arp table, would it just se...

What is the best switch to purchase for fiber. I need minimum of 6 connections?

Hi! Please help me.I have next 2 switch:Switch Ports Model SW Version SW Image------ ----- ----- ---------- ----------* 1 30 WS-C3750E-24TD 12.2(35)SE5 C3750E-UNIVERSA...

Hi, I'm attempting to perform a double translation but so far have not had much luck.I have a host directly connected to interface 0/0 on a Cisco 2600 that needs to send translated packets out on interface 1/0 and also be able to receive them back th...

When I in the office. I can remote to server 2000 with URL is: http://204.72.x.x:8080/tsweb/default.htm. But when I at home, I am getting an error: vbscripts: remote desktop disconnected. Please advice.

Hello All. We are using a Cisco 2524 router. We would like to be able to monitor the serial port utilization on this router using snmp. What is the correct OID to use for this? Thanks for your help in advance.