Switching

m facing problem in my cisco 2950/60 switches that some of the ports are not stable i.e. they keep on frequently changing its states. can anyone help me to find the cause and solution of this problem. log server messages are :09-17-2007 09:16:41 Loca...

Hi all, if I want to use PAT for my inside clients to access the internet how do I do this on my asa, do I create a static nat rule, then add the LAN as my source network, then in translated, use the outside interface, do I need to use the PAT option...

I have on my network several router 1700 series and switches Catalyst 2950 and I want to know how can I run ethereal on those babies to monitore what comes and goes

did catalyst 3560 swith supports port mirroring commands , if yes can i have the link for configuring the same.Rgds,mahesh

Hi all, can someone help. I have a setup, using a asa in transparent mode, switch A goes into inside of asa, then switch 2 plugs into outside of ASA, I have created an allow all rule, BUT i cant see the bpdu's coming through to the other switch, can ...

Hello all, I've been trying to research this error message that I received on my 6509 and I haven't been able to find it anywhere on Cisco's support documentation. I don't have access to the error message decoder so I am asking my fellow techies o...

Am I right in my interpretation of the data sheets that the little 2960-8PC does not support PoE, but the 3560-8PC does? If so, what was the rationale behind that design decision? I reckon an 8-port fan-less switch with PoE would be extremely usefu...

I have two sites set up pretty much identically. One works and the other does not. My configuration is as follows. I use 6500 series switches at both sites. The only real difference is that the configuration at the site that works runs in hybrid mod...

Hey everyone, this should be a quick once.I was under the impression that c2960-lanbasek9-mz.122-40.SE.bin should be okay to load onto the WS-C2960G-24TC-L,but when I tftped the file over to my switch and setup the boot sequence like so:BOOT path-lis...

How is the MGT (Not console) port on the 4948 configured?I cannot locate instructions for this in the documentaion for this device.

Hello all,My company is planning to move into a new building. We will be consolidating different buildings into this one location. Initially we will have 4 floors with 600 users, in the future we will assume 5 more floors and will have 2000 users.We ...