Switching

Hi I came across a formula. Time to detect a collision = 2 x Signal Propagation timeThis means that a longer network diameter will have a smaller data rate.10 Mbps = 2500m100 Mbps= 250m1000Mbps= 20mDoes this mean that this is the only factor that af...

currently, we are operating with hsrp in our network which enable us to manully load balance between our two 6509 switches. recently, we were given the task to investigate the glbp protocols and the benefits it could bring to an already established n...

hello everybody,the problem is that when I verified the status of interface vlan 1 on switch 2950 I found that interface is up and line protocol is downI can't find an explanation for thatcan any one help me?thank you

I have different cisco switch which are under different vlan member. so that can i use this cisco 3560-E switch under this layer of the network, which is working as a router and a switch.If not what are the lest price MLS that can substitute this swi...

I have 2 switches 1&2 on switch 1 i have trunk port with encapsulation 802.1q and native vlan 5 ,this switch is connect to switch 2 to port that is in access mode and on vlan 10.i have user on switch 1 in vlan 10 and there are also user on switch 2 o...

Hi all, is there any reason that lots of ports on my switch are getting receive discards/errors, I have had around 2500 in 30 mins, what is causing this on losts of different ports ?

Hi AllI have a small dobut.There are two L2 switches which are connected to each other through a trunk port.No spanning tree is running in the switch.I advertise Vlan 1 and Vlan2 on the first trunk link and Vlan 3 and Vlan 4 on the other trunk link.M...

HI ALL,Can u define The management VLAN and Native VLAN as per experience?

Is it possible to configure 2 routers (1700 series) in a failover configuration (1 as a primary and one as hot standby) to ensure 100% availability.

i have two 3548 daisy chained together and am getting the following error "%RTD-1-LINK_FLAP: FastEthernet0/47 link down/up 5 times per min" on one of them. did not get an error in log on the 3548 connected to this port. this occured for about 5 min...

Our network is running a collapsed core design with access layer switches which are 3560-48TS are connected to the 2 6509 core switches via fiber uplinks. There is no distribution layer, how can i take advantage of both of my uplinks to the core, sin...

The HTTP server responds with a 404 message indicating it can't display the home.html file. Is there some issue with 6509s running supe720s?

Hello,Does any one know how to set hyper terminal setting so scrolling will be available and won't go wrong?Regards,Ofir.

When I am trying to configure sticky on a 6509 ACE blade, I get the following error.jonoc-ace1/Prod-Banner-Portal(config)# sticky ip-netmask 255.255.255.255 address both MYSPECTRUM-HTTPS-stickyError: sticky resource not availablejonoc-ace1/Prod-Banne...