Switching

hi alli would like to traceout the ip address by the switch port, can anebody tell how we can traceout.

hello i'm a bigginer on cisco world.i don't know how to configure a vlan by subnetwork without associating a specifique switchports to vlan on catalyst 4503.pls help.

I have a cisco 827 and have make a static ip nat for intern webserver from the internet. This works great but if i want make a connection from my inside network to the webserver on the inside netwerk it doenst work. - I have no intern DNS server- Sli...

Hi NetPro,i got the error msg from log file, what is that mean actually ? %MISTRAL-3-ERROR: Error condition detected: TM_NPP_PARITY_ERRORregards,Kitten

Hi all, when adding 2 routes to a destination but using different next hops, you use a cost for failover right, how does the router know that the other end device is down ? or will this only work when pointing through 2 different local interfaces on ...

Wondering if anyone has seen this behavior on this switch and if a resolution is available: Switch loses connectivity on 10/100 ethernet ports. Power is on but, all ports go black. This switches provides connectivity to Cisco Aironet 1200 Access Poin...

Hi all, can anyone tell me why ftp is faster at transfering files over the web than http etc ?

Hi there,could someone share information on :1) How to password privilege level2) I need to be in enable mode 3) should not be able perform a conf t4) how do i do this.5) what is the privilege level Thank you. Appreciate your info here.Devan

We are opening a new office that is roughly 20km from another core site. We plan on provisioning 2 x DS3 between sites and likely have a requirement to support the same subnets (VLANs) at both locations. Let?s say we have our core site (SA1) and new...

guys a v basic confusion but i cant get my head around it........adding vlans can be done in two ways.....plz correct me if i m wrong.....from vlan database and from config mde....(vlan 33 enter) now guys plz make me clear that why two ways even if i...

Hi, I got this error frequently in my Cisco Catalyst 3750 (occurred in several ports) and did not understand what to do.Description: Interface GigabitEthernet1/0/19, changed state to upExplanation: The interface hardware went either up or down. Rec...

If you have RSTP enabled throughout the network, is there a need for loop gaurd or UDLD? can some explain to me the benefits/disadvantages of having UDLD and loop gaurd in a RSTP enviroment? maybe even a brief explination of how loop gaurd and UDLD ...

Hello,I have deployed 2 catalyst 6500 with 2x sup32 for each cat, I try to connect both switch?s by two 10G interfaces on each chassis (one in the standby and one in the active) but with no look, the only 10G interfaces that came up was the 10G int...