Switching

Can I install a WS-X6748-GE-TX in a Cisco 6500 running Cat-OS using a WS-X6K-SUP1A-2GE Supervisor module ?

Hi there,i need help on how to upgrade the IOS image of my 3750 without having to lose any information. It's actually for a client, and i wish to schedule a reload time...the image would be lifted from a tftp server, but i just need to know the steps...

I am a protocol tester.When a superior BPDU is sent to a switch port which is already in forwarding state, I want toknow whether the forwarding state will be broken and the port will issue a new proposal on its designated ports

Hi all,how do we give only interface level config command access and show commands for usergroup using tacacs server.Thanks in advance.Rgds,Rajeshac

If the e0.1 and e0.2 interface of a router has an ip add of 192.168.1.1 and 192.168.2.1 respectively both having subnet masks of 255.255.255.0, and this e0 port is connected to a switch, what should vlan1(management vlan) ip add be? What subnet shoul...

I configured a router to perform NAT to allow outside traffic into an internal web server that only accepts connections on port 443. Here are my configs (ip addresses have obviously been changed): interface FastEthernet0/0ip address 10.32.15.102 255...

Hello,Can someone explain me briefly what this command accomplishes.Better said,if you do not use the "no" keyword.ThanksKurt

I'm working on a military network so this scenario might seem a little odd, but I have had concerns brought to me by higher-ups about what device would be the best.Current we have a 100Mb incoming connection from the SDP router, our edge device right...

Hi All,Is there a way to monitor individual switch member in a stack? I mean like putting ip addres and using an icmp monitoring tool to monitor them 24x7?What is the message in the log (and level) if one of the member switch fail? Will the same mess...

Our network managment system is consistently reporting a reoccurrence in performance degradation on a nightly basis. Our core/dist layer is 2-6506E and access layer is 2960G's. Between the 10:20 pm and 10:30 pm CST, RTA for the same multiple device...

Hi!I am getting this error on Cat 4003;%SYS-4-P2_WARN: 1/Invalid traffic from multicast source address 6f:f0:ac:1e:22:19 on port 2/8.Can anyone provide me soluion.Thanks in advance.Regards,

G'day to all,I am setting up DHCP on a Cisco 837 and a Cisco 1841. Id like to know if its possible to give the client PC's 2 IP's each from different subnets. One range will be 172.16.x.x and the other a public IP range 136.x.x.x.Ive looked and asked...

Has anyone tested the XENPAK-10GB-LX4 with the 3750-16TD? Any problems. On the compatibility matrix, the LX4 is not listed next to the 3750-16TD. Thanks.