Switching

Hi all, does framerelay normally get put on a serial connection? i saw a router today with an e1 port on it, and they say its a frame relay connection, is that right ?

In the documentation "Quality of Service on Cisco Catalyst 6500", it talks about auto-qos and that it is applied in two steps. Firat at the system level, and then at the port level.However on my 6509/Sup720 (2.12(18)SXF5) with 48-port 6548-TX line c...

Hi all, im at my new job now, they seem to have a load balanced internet connection, 2 x 2mb, behind these 2 routers sits one firewall, what will be the most likely config of the internet routers ? as there is a default route on the firewall just to ...

I need some help with a cisco 1924 switch, I need to know if we can copy the flash to a tftp server and the running config, if so howthanks

Hi. Anybody has configured a router 805 to four(4) "lines" using X.25 (Visa, Mastercard etc...). There are any documentation?

We have a C4510R with only data line card. The power calcutator calculates 729 Watt of power and set as a minimum Power Supply the 1400Watt PS (see attachment). But in this case the 1300Watt PS can also be used. Or not ?Why does the power calculator ...

Hi,We have configured GLBP with round robin configuration. How do we test / check that every alternate request for outbound is processed by tow different routers ?Ho do we decipher # show glbp command output to see round- robin is working ?Thanx in a...

Hello All,I hav Cisco 2621 Router, i just ordered flash memory(32MB FS).I have installed the flash memory in to the router by removing older one, but as i boot the router router goes in to ROMMON as it dosent has any IOS, now i am trying to download ...

We have have a few instances of dot1x ports getting a err-disable with the offending mac being the phone MAC. Since the port is in single host mode that is the default behavior. It would appear its something with the phone bleeding packets from the v...

Hi,I had a small doubt that i need to know in cisco catalyt 1900 whether i can create multiple vlanIs it possible Thanx in advancevinoth

I have an existing stack of 375012ts and 375048ts with IOS ver 12.1(19)EA1c among them 375012ts is a master now i have to add an 375048ts with IOS ver 12.2(25)SEE2 so please guide me what steps should i follow.

Hi all, if I wanted to advertise a default route into ospf and also my other static routes, would i use default information originate and redistribute static both together ?

I have WS-C3750G-12S-E and WS-C3750G-24TS-E in an existing stack.It's Ios version is 12.1 (19)EA1c. I want to add an new WS-C3750G-24TS-S in existing stack. It's ios version is 12.2(25)SEE2.