Switching

Hi all, if I have 4 fast ethernet interfaces on my router, and also a vlan interface, can you have an ip address on each fastethernet interface ? and can you have multiple vlans on the router ?

Someone could please provide me the command i need to place (on 3560 EMI and 6509 IOS, but i think it's the same) in order to change login and psw for telnet and consolle access. (with ecritption too) thanks,simone

Looking for documentation on the NVRAM for SUP2. When sh ver with no config.(clear config all) NVRAM states total-512K;used-251k;free-261k. No line cards installed. Is this normal?Thanks in advanced.

My cisco catalyst 3550 is displaying the following syslog error: Syslog Message: IP-3-LOOPPAK Description: Looping packet detected and dropped - src=[int], dst=[int], hl=[int], tl=[int], prot=[int], sport=[int], dport=[int] in=[chars], nexthop=[int...

Hi,the show controllers utilization command always show 0 counters on a 3560 switch. Does anyone know why what could be the cause of it ?Many thanks,Laszlo

Privilege levels are from 0-15, where 15 is the full & 1 is the low & 5 is the medium, but what about the rest & also how do i make use of this in the Cisco ACS? because i am planning to make use of this privilege level in the group settings, like on...

What does everything think is a good size for logging buffer for large switches like the Sup 720 and 4506's ? The defaults are way to small and we want to increase them without affecting other processes . Default is like 8196 I believe. Just ...

I converted two of my new 6509's from CatOS to IOS today and now when I reload the switch it takes around 9 minutes to boot completely. During the boot process it hangs on "Initializing ATA monitor library" for about 4 minutes.s3223-adventerprisek9_...

Hi!i have to know about the LMS Software;it is Free to download Like CNA OR Need fees.10xs

HI!I have Users CONNECTED to Switch,VLAN 10;IP Address 10.10.10.100;i need to a script to Disable ports f0/1 -24 & renable these ports after 30Mts.1)what is the Script configuration on Switch2)how to configure it on the Switch3)how to verify it is wo...

Hi Experts!i have to know in which case we used these Command in the whole Switch:1)stp uplinkfast2)stp backbone fast3)the new one R-pvst4)802.1 w (Cisco proprietery Enhancment)

Hi, I am expereincing a lots of Dup Acks , Retransmissions, TCP out of order when i sniff the traffic on my DMZ lan . Digging through forums i only came by MTU/MSS size issues and Speed Mismatch, but there is no such situation in my case I have dell...

Hello,I think it is not possible to configure "natting" on the 4500 with the Sup2+... Is it possible with the SupIV and above?Thanks.Bjoern