Switching

Is there a way of gracefully shutting down a switch (CatOS) and a router (IOS) short of powering them down?Thanks.

Hi, I want to configure two MSFC`s in the same chasis. By example I have in the first MSFC Interface Vlan 56ip address 156.175.20.1 255.255.255.0ip helper-address 156.175.28.202If I want to configure the second MSFC for HSRP do I have to change the ...

Hi all,I have already posted this, but it has disappeared.This is the question.My friend has a 800 series router connected to DSL through an Alcatel DSL modem, and has 5 public IP addresses he can use.He wants to assign these addresses to some server...

HiThis is quite off-topic, but I cant find an ontopic-forum for my question. Sorry. :-)Anyone who knows where to find a Cisco-logotype, high-resolution? I need one to print on CDR with VPN-clients to send to my endusers. I have looked all over cisco....

I have 2 Cisco 2950 switches one for each network in my office. One switch is full the other only has 8 ports used. Since both swithches are 24 port I though I might be able to split the switch on the underused network and allocate 12 ports on it to ...

Is there anybody using IBM Director in conjunction with blade center servers? Supposedly, the IBM DIrector is communicating to the blade servers via a Service Location Protocol. Can anybody please let me know what port this protocol is traversing and...

Hi,We have a Cisco 2500 series router supplied by our Internet Service Provider for use with the leased line for internet connectivity. In that NAT was enabled to connect it to our local network. Now when we are trying to connect to our client in ano...

Need help connecting two 4507R catalyst switch using the Uplink ports. Both switches are in same building but at 2 ends and there is a fiber connection in place between those two sides.

I have inherited a couple of Cat-2950 switches and noticed the following config on ports:interface GigabitEthernet0/1 description blade1 switchport access vlan 65 switchport trunk native vlan 2 switchport trunk allowed vlan 2-4094 switchport mode acc...

A 2924 connected via an feip on a cisco 7000 produces large numbers of CRC errors and eventual loss of connectivity, more errors occur on the 2924 than on the 7000. However, both the 2924 and the feip work fine when connected to a cat5 or cat6 port u...

Hi all,Is there a way to find out traffic information from source IP to destination IP, like ip accounting used on routers, on the catalyst 2950 switch. My switch has the standard image.Also what performance impact would it have on the switch, if pos...

We have users in Boston who will be using a PIX in NY for Internet access. We also need to NAT the destination addresses for the packets leaving Boston for NY, so we are thinking of using a proxy server in NY and point to its IP NATed address from th...

Hi,I am reading up the Cisco press books and have some difficult understanding whether there is a difference in designated port and a root port?

I have a 6 switch cascaded stack with a rendundant link using 6 Gigastack GBICs. Is it possible/advisable to pull in a 7th switch with built-in RJ45 1000Mb uplinks, into the stack by putting 2 x GBICs into 2 of the 6 existing switches and completing ...