Switching

Can anyone explain me the concept of vlan translation.Kindly also provide some links.Thanks in advance.

How would you advertise IGP routes into an EGP: by redistributing routes from IGP to EGP or via static network statements? or some other ways. can someone please Explain it to me.thanks

Hello, I have a complex NAT setup where I have 2 Interfaces on a Cisco 3600. Both of these Interfaces are FastE. I will refer to them as Fast 0/0 (External) - External IP'sFast 1/0 (Internal) - Internal IP'sI have MANY subnets on Fast 1/0 and have ...

can someone tell me What is the major effect on routing of configuring your routers with the ‘no ip classless’ command?thanks in advance!!!

Hi Folks, I have a 7300 router, running 12.2.27sbc1 the only problem I have is output of the show config, it is garbled, the show run, show start, are ok, and it is garbled at the same portion of the config always, there is no problem with my session...

when we talk abt difference between bridge/switch we say that switchs r hardware based and bridges r software based....both work at layer two i m not just getting the concept that whats does it means can some one plz explain it to me...thanking in ad...

Hi,I have been looking at two Cisco routers for my home/work network. They are the 1811 and the 871 series.My network consists of 1 2K3 SBS (It dose my DHCP, Domain Controller, Wins, and active directory.), 2 Cad stations, 1 Email/web PC, 1 Notebook,...

hi all,when changing catalyst switch configuration from Hyper terminal of my PC, I can not use the up arrow key to recall the last command. when I hit the "up arrow key" , some strange characters appears on the command line and executes those without...

a layer 2 catalyst switch with 24 10/100 port like 2960,1- this guy has 24 mac addresses for each physical layer 2 interfacesand the switch itself has one independent MAC address right?2- if that is right, which MAC address is the visible one to the ...

can we ban MAC addresses (port based ACL) on catalyst L2 switches?tx in advance

What would be an appropiate cable connecting the 3550 catalyst and the 3560?3550 has 2 gbic ports, while the 3560 has 4 spf module slots.

I have 11 units running on XP. I have no problem sharing files except for 1 PC. I've turned off all firewalls. I've done ping tests to and from this PC and there seem to be no problem.Is it possible that my network has limited me to 10 PCs? I barely ...

I am new to using cisco routers. Currently have 15 dlink routers but I will be receiving 15 837 routers to replace these. Question is Currently I use the dlink routers to assign ip addresses for our lan. this is done by cloning the mac address to ...