Switching

Hey all - I set up a lab to mess around with at home. The switch is an ancient dinosaur, but still it gives me something to mess with. Does the 1900 xswitch support a reverse telnet port? Anything I need to be aware of in configuring the line? I can ...

My idea is to connects the AP to the distribution layer switch(3550). i would like to know:1) Per AP, how many connection is the limit?2) On the 3550 switch, how many AP can i connect it to? As many as i want? will ir really slow down alot?3) Do i st...

hi,presently we are having 230 computers all connected through switches with ip add. range 192.168.10.1/255.255.255.0, now we have another building and there will be another 100 computers. we are thinking to give ip add. range from 192.168.20.1 onwar...

What do the persistent-data and private-config files contain in nvram on a 12.3 IOS router? Neither of the files have permissions available to the logged in user and seem to be unaccessible. Can you change permissions on nvram files or are these fi...

Is there a way of gracefully shutting down a switch (CatOS) and a router (IOS) short of powering them down?Thanks.

Hi, I want to configure two MSFC`s in the same chasis. By example I have in the first MSFC Interface Vlan 56ip address 156.175.20.1 255.255.255.0ip helper-address 156.175.28.202If I want to configure the second MSFC for HSRP do I have to change the ...

Hi all,I have already posted this, but it has disappeared.This is the question.My friend has a 800 series router connected to DSL through an Alcatel DSL modem, and has 5 public IP addresses he can use.He wants to assign these addresses to some server...

HiThis is quite off-topic, but I cant find an ontopic-forum for my question. Sorry. :-)Anyone who knows where to find a Cisco-logotype, high-resolution? I need one to print on CDR with VPN-clients to send to my endusers. I have looked all over cisco....

I have 2 Cisco 2950 switches one for each network in my office. One switch is full the other only has 8 ports used. Since both swithches are 24 port I though I might be able to split the switch on the underused network and allocate 12 ports on it to ...

Is there anybody using IBM Director in conjunction with blade center servers? Supposedly, the IBM DIrector is communicating to the blade servers via a Service Location Protocol. Can anybody please let me know what port this protocol is traversing and...

Hi,We have a Cisco 2500 series router supplied by our Internet Service Provider for use with the leased line for internet connectivity. In that NAT was enabled to connect it to our local network. Now when we are trying to connect to our client in ano...

Need help connecting two 4507R catalyst switch using the Uplink ports. Both switches are in same building but at 2 ends and there is a fiber connection in place between those two sides.

I have inherited a couple of Cat-2950 switches and noticed the following config on ports:interface GigabitEthernet0/1 description blade1 switchport access vlan 65 switchport trunk native vlan 2 switchport trunk allowed vlan 2-4094 switchport mode acc...

A 2924 connected via an feip on a cisco 7000 produces large numbers of CRC errors and eventual loss of connectivity, more errors occur on the 2924 than on the 7000. However, both the 2924 and the feip work fine when connected to a cat5 or cat6 port u...

Hi all,Is there a way to find out traffic information from source IP to destination IP, like ip accounting used on routers, on the catalyst 2950 switch. My switch has the standard image.Also what performance impact would it have on the switch, if pos...