Hi I client did a ios-xe upgrade from gui but accidentally he loaded a version to c9200. The switch is not reload it yet, so we want to know what is the correct process to do a rollback. I found this command request platform software package install ...
what is routed port and meaning of that
Hi Team , We have 4 9300 switch that are part of stack , the stack port of switch-3 port 2 and switch-4 port 1 is down as shown in the diagram below . In this case what happens to data plane ? Will we be able to use the interface of switch 3 and 4 ?...
power LED blinking on cisco 2960 switch, everytime after restarting ,the switch is working but after sometime it's again facing connectivity issue.
We have there devices that we need to isolate them. what is the best way to isolate them from other VLANs. Suppose that device A,B and C Connected to Vlan1 and we want to allow them connect only to particular Server IP address in Vlan2 which is runn...
Hi All,We are getting input error on switch interface connected to Cisco WLC 4404. Interface GigabitEthernet1/2/20 & 2/2/20 are connected to the WLC through a Port-channel 43.GigabitEthernet1/2/20 is up, line protocol is up (connected) Hardware is C...
hi,i'm trying to configure AAA on a nexus switch. could someone advise the difference between.aaa authorization commandsvsaaa authorization config-commands my google search only points to cisco config guides. i would like to know if one is preferred ...
Need help to resolve continuously right mark indication
After copying the new iOS from the usb drive I get the following message when I run the bot system cmd. "File system with suffix not allowed" any thoughts on getting this command to work. also the current iOS is a .pkg while the upgrade is a .bin. no...
i have one switch that is not showing logging on console.how do i enable it back as i need to view my logs when i telnet to the switchthere is one command on my switch boot-start-markerboot-end-marker!no logging onenable secret 5 $1$And9$ 1#sh logSys...
Hi, Kindly advise if IP domain name configuration is needed on core switch. What are its uses? sw(conft)#ip domain-name cisco.com
Hello, I would like to know how OSPF picks a path from two available with the same cost when maximum-paths 1 comand is applied. An example using GNS3: Before maximum-paths 1 command R1#sh ip route 77.77.77.77Routing entry for 77.77.77.77/32 Known vi...
Hi everyone, can I know the throughput of the switches, I mean the whole throughput that the switch can process at a period of time, does it has a formula for example (sum the speed of all ports!) or it is has no relation to the port speed? This is t...
Hi everyone,I have 3 switches, 6500, 4500, 3700 series, is there anything that can tell me what are all the SFPs types that are compatible with these switches.I need to know if the SFP will be compatible before buying it + all the compatible SFPs. Be...
Hi,I would like to ask about multicast.I have two clients to get the video stream from video server. Our clients are connected to L2 switch. This switch connect to our customer switches.Customer switch connected to their network and video streaming s...
