TelePresence and Video Infrastructure

Hi Guys,  My Customer have solution Telepresence and is with follow problem: On intermittent days and times, our TMS has presented the following message during the videoconferences.  “Warning Instance: No response from main system – Error: No contact...

Anyone successfully deploy SIP w/ TLS/SRTP with an ITSP? Doesn't seem like it's something that is done very often - was curious if anyone has actually successfully deployed it.   -Thanks

Hi,   We are currently deploying SX80's around our organisation and are struggling to get the layouts we want.   The SX80's are only deployed with 2 screens for Output, both currently connected to the HDMI Outputs 1 & 2. Our End Users once in a call ...

Hi! I need your heIp to know is it possible to disable chat on streaming web page of MCU 4520?  In alternative: is it possible for MCU to deny every message sent via chatbox? Current ver.: 4.5 Regards

HiI would like to know where can i get official Cisco User Acceptance Test for Telepresence (Cisco QuickSet SX20)Is the mentioned official document exist? If so, could you provide a link or refer me to someoneThanksBest RegardsSyahrir Mohamed Yatim

Hello,   We have SX20 conference units in each of our 3 main offices. We have just started to use Desktop sharing over internal Video conferences and this works well when using a Windows PC. However, when we do this with a MAC Book the desktop when s...

Hi All, I have configured CMS (2.1.5).Trying to call from my space to my desk extension through (option use a phone for a call). Is this possible or not. If yes then what configuration needs to be done.

We need to configure the autoattendant in CMS1000 to receive the calls and, according to the value entered, the call will be sent to the respective conference.   By default, it has only the message "welcome to a cisco meeting, you are entering the me...

Cisco C20 codec status show this registration retries expired error. Callsetup mode is gatekeeper, ip is correct, id correct, portallocatin dynamic.   Working normal but suddenly this happened. What can be the problem?     

Good day, we are currently running with the new Spark Room Kits. I would like to find out if there is a way to remove or move the default buttons around on the Touch 10 Home and call screens. I managed to add macros for a custom speed dial button but...