In one of our conference rooms (small huddle room; 4 chairs) we are using a DX70 as a telepresence endpoint with the Android firmware and using the HDMI out to project to a 55" TV. We have gotten the push from administration to switch the room to C...
Does anyone know how to disable the PC port on the DX70, and DX80 that are registered to the VCS and not the CUCM ?? I can't find it in the browser when logged in or in SSH. VR Chet
hello I've format flash of this equipement, actually need load the reléase but I have problema %Error opening tftp://255.255.255.255/ap1g3-k9w7-tar.default (connection timed out)
Have a edge 95 with HD camera ... Problem is I can't drive thru menus using the remote TRC4. Camera LED blinks when pressing buttons on remote but nothing happens on the monitor menu's ?? Also the main camera not selected and no video transmit when c...
I read that MX and EX end points have an MCU embded. Is that mean that we can use video conferencing without CMD or CUCM ? Thank you,
Hello everyone, We have an issue adding a C90 endpoint to TMS. The endpoint was previously there but was purged (did not manage to get address book and had no response error in TMS). When trying to add it again we get an error: Details: hostAddress...
I am running VCS X8.5.1 on my VCS Control. I have a cluster of two VCS Control gatekeepers. Problem I am seeing is that my VTC systems that many of my VTC systems set to register to VCS Control #1 via IP are showing a critical warning on the TMS and ...