Hello!We have a programmer buildning a touch interface for a control system ( Normaly we try to use touch 10 panels - but this control room needs too much custom interaction for touch 10 to be functional).Any how. One thing we require is OBTP functio...
Hello all,I have an SX20 endpoint running CE9.15 that I have used to call Webex meetings. I need to start calling a colleague via Zoom meetings, and the Zoom host does not permit unencrypted H.323 or SIP connections. Zoom uses AES-256 encryption.Fr...
I'm trying to understand how often the self diagnostics run and what the conditions are for fault/resolution. The information doesn't seem to be published anywhere.
Dear Experts,I am facing unknown call with same my telepresence WAN IP address on my Standalone Cisco SX10 and SX20.Connection drop when this unknown call initiates in every 15 minutes or sometimes withing few seconds.Both SX10 and SX20 are using as ...
HelloI just added 3 "Cisco Webex Room Kit Plus" to CUCM, TMS and TMS-XE. Everything works fine, except that all 3 units showing the warning below: WARNING: HTTP FeedbackThe HTTP Feedback for slot 3 can not be delivered. There might be a problem with...
Hello, i have several PHD1080P12X Cams here and a C40 codec.all cams but one is found by the codec if i directly connect the cam to the codec. the one that is not found by the codec can be controlled via serial by a visca serial controller. another p...
Works great! A meeting is created on the portal at the user's space. A standard notification with Accept / Reject comes to the mail, after which the meeting is recorded in the Calendar (if you Accepted it) with an alert 15 minutes in advance. Great, ...
Hi,Lately, some new Cisco Room Kit Mini's where installed along with a Cisco DX80. All devices are registered to a 3rd party SIP server (hosted on our internal network) and connected to Cisco 1Gbps interfaces.However, when we initiate a videocall, th...
I had an SX20, registered to CUCM, that was running TC7.3.14.164ea0b. I configured the SX20 to upgrade to CE8.3.8 (as a stepping stone to CE9) The unit downloaded the CE8 firmware, installed it & rebooted. But after rebooting, the unit fails to come ...
HelloIn coSpaceTemplates/GUID/accessMethodTemplates has a field uriGenerator. I want it to auto create uri for Host Method Access as room.host.3030 (3030 it is secondary URI for coSpace from LDAP sync). It is realy? How make regex for it? "the expres...
I upgraded my C20 from 5.1.8 to 6.2.1 and it would no longer register with VCS with message 401 unauthorised. I noticed the SIP Profile 1 Authentication LoginName and Password were empty. When I attempt to add the username and password information ...
