Unified Computing System Discussions

Engage with peers and experts on UCS and HyperFlex topics.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

I have configured LDAP authentication through Microsoft Active Directory for the UCSM system. It's been working well. I went to configure LDAPs for secure authentication with my LDAP servers today and I received the pop up message: "Warning: Port 636...

DemPackets by Beginner
  • 1029 Views
  • 2 replies
  • 0 Helpful votes

We have a Cisco C240 M3S server that we have imported into our UCS Management Software. We have some PCIe cards that can run warm under load, and due to this we had changed the 'PowerPolicy/FanPolicy' to High Power, which dropped the temps a good 10C...

Is it possible to connect the same pair of Fabric Interconnects to two(2) different Datacenter Switches and restrict  a subset of our B-series blades to only use the new datacenter switches while the remaining blades would continue to use the current...

dkjones21 by Beginner
  • 165 Views
  • 1 replies
  • 0 Helpful votes

Greetings UCS Community.  Somewhat new to UCS system and have had to do extensive troubleshooting to get our Fibre Channel SAN talking to our FIs.  I was wondering if our 6248 FIs support the use of FCPING or FCTRACE to the upstream FC switch we conn...

When we install Windows Server 2012 R2 Update (specifically using Windows Server 2012 R2 Update 1 ISO), mouse and keyboard does not respond after server is installed. Is it a known issue or is there specific firmware or UCS version requirement to sup...

ucthakur2 by Beginner
  • 1589 Views
  • 12 replies
  • 0 Helpful votes

Cisco Unified Computing System (UCS) Mini Architecture, Troubleshooting and Upgrade Ask the Expert Continuing Discussion(Live Webcast May 12, 2015 at 10:00 am Pacific Time / 1:00 pm Eastern Time)Ask questions from Tuesday, May 12th, 2015 to Friday, M...

Lisa Latour by Frequent Contributor
  • 1422 Views
  • 4 replies
  • 0 Helpful votes