Unified Computing System Discussions

Very strange effect:Firmware server autoinstall from 2.0.4b to 2.1.3fI created a host firmware package, and then I found, that the board controller asks for a further reset ?? see screen shotsI thought that HFP does Bios, CIMC,.... all in one step.Be...

Hi all,i have 2 ucs c460, 1st ucs i can boot into webios to create raidthe other 1, pressing ctrl+h , still cant boot into webioswhen i check bios at boot options, there is no pci raid adapter detected, only cdrom,network card and efi shellbut at cim...

Hello,I have built a Windows 2012R2 Hyper-V cluster on B200M3's 2.21d firmware VIC 1240. I was unable to get the OS to enable VMQ on the NIC's that I presented to Hyper-V for VM networking. I finally found that I needed to create a  VMQ Connection po...

Hello all,I would like to know how to check the "overall state" of the UCS C220 M3 rackmount server.I have searched and walked through a lot of OID, but I can't find which one is the "Overall Server Status" for example ?The goal is to poll the main i...

Welcome to the Cisco Support Community Ask the Expert conversation. Learn and ask questions about Cisco Unified Computing System (Cisco UCS) Central.Starts November 7th, through 21stAs organizations scale their Cisco UCS infrastructure, managing it c...

We have a senerio with some of our UCS domains.  when we add a new storage array some paths will login to the array but not all will login until we reboot a host.  We have 4 UCS domains 6140x, 6248 and 2 x 6296.  the older 6140 seems to always login ...

Fw 2.0 3c I have several major "link down's" & "bmc-pre-config-pnuoslocal-failed" - where acknowledge fault is greyed out. There are many other major events I can acknowledge and clear though. Thanks    <faultInst ack="yes" cause="link-down" changeSe...

Hello, I have a LSI MegaRAID SAS 9271-8i installed in a C220 M3 (in PCIe1). When I go to CIMC, I can see the adapter there and I can create RAID arrays. I can set the first logical drive to be the boot drive too without a problem. If I boot from ESXi...

The rackmounts are already powered off and removed from rack without decommisionning from UCS manager. Now the stale rackmount server is showing in UCS Manager. How to delete/decommision the rackmount now?

Hello,What is the proper way of configuring Boot Policy for C220M3 which has 4TB disks installed and is managed by UCSM 2.2? I try to configure Legacy and UEFI and I cannot install the OS in silent mode. The OS sees usupported device.Best regards,Krz...

Hi There doesnt seem to be a command to apply ssh on the vty line on the nexus platformIs this automatic or am i missing something as i have to write a security document to convert ios commands to nexus and i am stumped when it comes to ..#line vty (...

Hi, I have today installed a new IO Module into one of our chassis (2208XP into a 5508 Chassis).  But it has not come online.  There are lights on the IO module, however uplinks from that to the FI are down.  The ports on the FI are down.Error messsa...

     Hello,when I start the KVM launch manager and launch a KVM, he ask me for username and password (again?) and for an IP-address.AFAIK this should not be neccessary, shouldn't it?best regardsManfred