Unified Computing System Discussions

        I would like to find an explanation of this error messageCan't find it in http://www.cisco.com/en/US/docs/unified_computing/ucs/ts/faults/reference/2.0/UCSFaultsErrorsRef.pdfCisco UCS Faults and Error Messages Reference August 2012

            With Andrew Nam Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn and ask questions about Cisco Unified Computing System (UCS) Director with Cisco expert Andrew Nam. Cisco UCS Director was...

Hello, im working on a test deployment of UCS Central.  We have a Spare pair of  UCS 6120 FI's with a Chassis and blades for the test.We have built out the UCS central server,  and registered the pod with UCSC.  I have Set all settings to global, and...

UCS V2.2.1b, FC switch mode, Netapp filer direct attached with FC.SP with 2 vhba, one mapped to fabric A resp.B., 2 FC target end point, one in fabric A, resp. B.If I check the zoning done by UCS, I actually see 4 zones (SIST) ? why ? I would only ex...

Can someone please explain, what second-level boot devices are used for ?In the documentation it says:   For Cisco UCS M3 blade and rack servers in UEFI boot mode, you can select both top-level andsecond-level boot devices. For all servers in legacy ...

I have a UCS B200 m3. I would like to have console access from a termial server directly to the blade. Is there anything that I need to enable on the ucs manager?I can go into the ucs manager and click on "KVM Console" and get a session, but I need t...

Hello,I actualy did a UCS firmware upgrade from a mixed 2.1(1a) and 2.1(1b) to a full 2.1(3a) version.Chassis are 2208XP, Fabrics are 6248UP and blades are all B200-M3.I use firmware policy to update the firmware on the blades.Here are the current ve...

New deployment of a pair of 4500X in VSS mode and Cisco UCS.FI-A has 1 10G link to each 4500XFI-B has 1 10G link to each 4500XHow should the ports and port channels on the 4500X be configured for UCS uplinks?

I know how to set a remotely authenticated/authorized users Role using the Radius av-pairs with UCS. What Radius attribute/av-pair syntax is needed to set the users Locale within UCS? I have tried shell:roles="role@locales" and shell:locales="locale ...