Unified Computing System Discussions

While planning for an upgrade from 2.0 -> 2.1 we noticed the warning about Default Zoning not being supported in 2.1(1a) and later releases. Is it possible to reconfigure and disable Default Zoning without causing any disruptions?The system is runnin...

Good days Gurus,I am being tested in the emulator of UCS, the characteristics of Local Zoning of the fabric. The versions are not saved! that I am using are :Cisco_UCS_Platform_Emulator_2.1.1ape2 and Cisco_UCS_Platform_Emulator_2.1.3aPE1.The steps th...

Hi,In our environment, there are 4 B440 servers using vic 1280. When i tried to figure out which FC uplink port each server is using, 3 servers show the FC VIF Path is unpinned (picture attached), only one shows the current FC Port (1/30).Is anyone h...

Hi All,I have a customer who is look to double the memory allocation in their B200 M3 Server blades.At present they have deployed 8 x UCS-MR-1X162RY-A (16GB DDR3-1600-MHz RDIMM/PC3-12800/dual rank/1.35v) so wanted to verify if there are any concerns ...

Hello,I am trying to assist my customer develop a tool to generate inventory/health reports and part of that involves logging into the C-series system using PowerTool CLI - Customer is able to login by using local authentication (user-id and password...

Hello, i have a problem with UCS C220 M3 with 4 SATA drives and UCS-RAID-9266CV controller.I try to install ESXi on this server.- I have download Cisco customization *ISO ESXi image ( try different versions 5.0, 5.1,5.5)- Setup CIMC, set ip parameter...

Hi allI have a straightforward setup, NAtive FC portchannel from FI to N5k to NEtapp.THis all works fine as Blades are booting off LUN and can see their data LUNs.However when I run lunlist on an adpater I get no output...here is the ouptu on thet Ne...

Hi,I noticed the fans on 6248 FIs are extremely loud. The GUI shows then rotating between 11k and 15k rpm.Is this normal operation?The FIs are really loud, even louder then a chassis full of blades.This bothers some of my customers with smaller data ...

Hi, i wonder if i could use a vic 1225 as hba in a standalone implementation with a C240?, and if this is possible, what i need?

Hello,I am in process of setting up Remote Syslog for our UCS managerI have done the configuration as per Cisco official document at http://www.cisco.com/en/US/products/ps10281/products_configuration_example09186a0080ae0f24.shtmlI would like to under...

Hello All,I finally got several of my UCM's up to proper firmware to use UCS Central, but I am having a couple of issue.  WHen I try to lauch UCSM from Cetral, I get the error depicted in central.png stating can not access UCSM at 10.18.102.42 and th...