Unified Computing System Discussions

Hi there.I'm building out a ESXi host (or two) on a UCS with B-series blades. I'm running into trouble with getting the ESXi hosts to connect to the LAN. I've got two vNICs added to each blade, and ESXi sees the NICs as connected. I've also associate...

Hi everybodyI have a C200 M2 with a 1064E raid controller and two SAS disks, but I am not able to configure a raid 1. I have installed firmware 1.4(3k). Please see attachments for more information.Did anybody ever have the same problems?Thanks in adv...

Upgrading the nexus 1000v, we wran the pre-upgrade utility which failed at step 7 with this error:========= CHECK 7:  ========= Checking for Non-system Native Vlans in System Port-profiles.... Note: The duration of this check depends on the size ...

We will setup a UCS system with EMC iSCSI storage. Since this is my first time, I am a little insecure in the design, although I have aquired a lot of knowledge from reading in this forum and doing various courses.We will be using the 1000V.1. Is it ...

Hi,I'm hoping someone can help out with this,I have a setup with 2 Nexus 5548's connected over a vpc peer link and a keepalive, These two nexus switch's have a standard VPC connection to an upstream 6500. this is working fine,Then there are multiple ...

I've configued UCS direct connecting into the SAN before, but not SAN switches.  My understanding of the main differences between the two is this:1) With SAN switches, you configure vSANs.  To do this go to SAN tab -> SAN Cloud and configure your vSA...

I have read conflicting information regarding both Ethernet and native FC uplinks to the same Nexus 5548 switches – I am looking for clarification if this is supported or not?Secondly, when can we expect  support for FCoE from the 6200 north to 5548U...

I have a chassis with four B200 blades running 2.0(2q) code. ESXi 5 is running on the blades. There are two UCS managers in a cluster and I wish to upgrade to 2.0(3a)I upgraded the code from 1.4 a few months back but the system was new and wasn't run...