Unified Computing System Discussions

Environment:One chassis, 6 blades, B200-M2Two Fabric interconnects, 6120XPOld firmware: 1.3.1nNew firmware: 1.4.3sProblem:When we activate UCS Manager from 1.3 to 1.4, we encountered all the 6 blades reboot suddenly and this does not match what the d...

Is it possible to connect a 2248 downstream from a 6120 and have it act as a fex or is that not supported?

I'm a newbie to UCS C series, customer has C-200 series servers. All are working fine customer just called and mentioned there was an Amber light in one of the servers. I checked the CIMC log here is the Waring and Critical error shown in the log CRI...

Hello everyone!I have this network configuration:6500 connected with 6120XP using a trunk port with all VLANs and VLAN 1 set as the native VLAN.In the UCS LAN Cloud are these VLANs:VLAN abc (400)VLAN cde (401)VLAN default (1) with native=yesVLAN 1 is...

Hello all,I have a problem with vnic/vhba placement policies on an UCS-B:When a configure a Service Profile, evrything is good:- I use a "specify manualy" vnic/vhba placement policy  and can create this configuration:- vhba 0 : Order 1- vhba 1 : Orde...

Pardon the picture, I don't always have access to visio. We have a home office and DR site connected via two 10Gb links. Those are port channeled on VSS pairs on each side. We are trying to connect fibre channel - or FCoE - between the two sites, whi...

Hi,Before deeping dive into the installation process of Nexus 1000v, I was wondering to what extend the vCenter Server all-in-one appliance (vCSA) was supported.It seems the vCSA has some limitations (e.g. no support for the Update Manager), which mi...

Hello,Is there any document out there where to find a really comprehensive info about configs in the BIOS Policy for Service Profiles (not enough meat in the UCS Config Guide)?? When to leave "platform-default"?? What is the "platform-default" value ...

Where can I find design guides that specifically address Cisco supported FCoE topologies? I have documents that detail supported configurations of vPC, FEXs and NK5s, but none that include FCoE. With FCoE, there are special considerations to be made....

Hi, we have 6 ESXi 5 running B200 M2 blades running fine (with boot from san).This week we got 2 new B440 M2 Blades. We can install ESXi 5 without problems on the desired LUN but when we reboot the server we get:"reboot and select proper boot device ...