Unified Computing System Discussions

on page 4 of the Release Notes for Cisco UCS Software, Release 1.4 it says - VMware ESX and ESXi3.5 Update 4, and ESX and ESXi4.0 are not compatible with Intel 56xx processors.  55xx processors are not affected by this limitation. What specifically d...

HelloUCS Environment (Manager, Interconnect etc.) Version 1.4.2 .I heared that with version 1.4.2 it’s now possible to answer the question “do you want reboot now or later”.I heared also that this one need a policy. Can somebody tell me where and how...

Dear NetPro gurus,One of my customers has recently purchased CUCM 8.5 with a C200-M2 server.  However, together with the server, it only has a VMWare license key but there is no DVD for installation.The Cisco Product code my customer has purchased is...

Hi:Very new to UCS Call Home.Do I need a valid Cisco Support contract to configure UCS Call Home feature? What is the differences between UCS Call Home and Smart Call Home? Do I need Smart Call Home to ENABLE/CONFIGURE UCS Call Home?Thanks.SiM

I tried to log onto my backup 1000V by logging into the CIMC, then running "connect host" to get to the 1010 application on the standby box. So far, so good and I successfully log into the 1010. Then I run "login virtual-service-blade vsm-1" and I ju...

Hello,I am experiencing a weird problem. Following is my setup. A side 7018 --> 5548 B side 7018 --> 5548Port-channel 101 with six ports between 7kA and 5kA and B vpc 101Port-channel 101 with six ports between 7kB and 5kA and B vpc 101 On 7kA no issu...

Haven't had a chance to play with NxOS too much...Is there any qualitative difference at all between IOS and NxOS with regard to the configuration, functionality, and deployment capabilities and scenarios of PVLANs?Thanks

Hi, Cisco Gurus:Please help me in answering the following questions (UCSM 1.4(xx), 2 UCS 6140XP, 2 Nexus 7000, M81KR in B200-M2, No Nexus 1000V, using VMware Distributed Switch:Q1. For me to configure vPC on a pair of Nexus 7000, do I have to connect...

Hi AllI seem to be getting the following error messages in the fault logs and was wondering if anyone could shed some light on this:ether VIF 2 / 1 B-752 down, reason: VIF Hold Down.The server uplinks all report as being ok and the port channel seems...

Hi:Is the  default System QoS configuration still the same for UCSM 1.4(xx), from what I understand till now, only best effort and FC are enabled (each with 50%) with FC as lossless?Please help as I need to deploy QoS in ESX setup on UCS Blades with ...

Hi:New to UCSM 1.4(xx). When I create a new VLAN for customer, I saw the following, please help to explain:Sharing Type: None - Default, I presume. Should we use it most of the time?Primary: When do we use this?Isolated - is this for Private VLAN? Wh...