Dear Netprosi have call that hang on my 5300 ver Version 12.3(10a)any way for me to disconnect that specific call manualy without disconnecting other active calls?tks
I need config a group in a translation rule and fail, any body can help merule 1 ^123(1-9) 3456 any subscriber Incorrect format for Translation Match Pattern regular expression must be of the form ^(\^)?(\+)?([0-9,ABCD.*%?#]+)$ Invalid match ...
Hello,Is there anyone who could give me a short example configuration of an Cisco 1760V Router with an VWIC-1MFT-E1 Interface.how should i configure the E1 Interface to get the connection to the Voice port and how to configure MGCP.I Only did H323 Co...
I am new in Cisco so pls helpI have a Cisco AS5400, Can I used the Cisco to support SIP? If can what should I do and any extra requirement need to support it.
Hi,I have configured SAA (service assurance agent) and PSTN fallback feature between two of the voice gateways in our company. I have confiugred SAA as per the following configurations VoIP fallback config:Fallback Mode : ActiveUsing delay & loss thr...
Hi Guys.I´m trying to debug h.323 events but I can´t. I turn on debug cch323 but I got nothing, Of course the GK is proccessing a lot o calls and the terminal monitor is on as well the logging is at debugging level.Runing IOS 12.3(8)T5, C7206.Is it n...
CCM 333 with 2651XM connects to DMS100. The caller ID were able to display on the called party when the GW is MGCP. However when we switch to H323, it always display the main number. On the deb isd q931 it shows the DID number. It tells me that the r...
Hi!! I'm connecting a cisco 2610 to a nortel meridian, to connect 2 E1's for voice, so i'm using to set the calls in the network sip protocol, but i'm having troubles with the authentication in the proxy sip. How can i pass the credentials to the pro...
hello. i have ccm and cme. ccm has one ip phone ( number is 1000) cme has one ip phone ( number is 2000) i configured below. but it does not call each other. dial-peer voice 555 voip destination-pattern 2000 session target ipv4: 192.168.0.1 --> cme g...
I need to disconnect (force failover) of calls on a gateway, so that we can upgrade the router. Any thoughts on if and what the potential syntax or procedure (CCM) might be? Thanks.
While looking in the event viewer of the pub, I noticed the dpa and pri had unregistered from call manager. I looked at the physical memory and noticed actually memory usage is 98%. Could this be the cause of the devices unregistering constantly? Tha...
Hi,When using on-ramp t.37 gateway to detect fax calls, using the script called "app_fax_detect.2.1.2.2.tcl" the CNG is not detected.DTMF activation (pressing 2) works, but CNG is not detected.Any ideas ?Avner.
Hi,I have recieved one configuration file.There the loopback IP is defined whereas it's a point to point connection where i think one serial,ethernet and e1 controller is required.Can anyone suggest me why this loopback address in being use in the co...
Hi,I have problems with interoperability between cisco 3725 softswitch (IOS 12.3(9a)) and 7513 (IOS 12.3(7)T1)gateway; I set "media-flow around" at 3725ss to serve only h323 signalisation, no media proxy functions on this device, but a lot of calls I...
