Voice Systems and Accessories - Small Business

                   Does anyone know how or if the join tone on conference calls can be adjusted on a UC560?  We get a lot of complaints that it is too long and loud.  Of course if I turn it off I get complaints they don't know they have joined the co...

Hi -A while back, someone posted ..." Bill.Lopez@Strategic-VA.com Oct 27, 2009 10:02 PM I  can fax good in but when I call the number I hear the prompt like I  should but when I press a button or just wait the 9 seconds it  disconnects my call. Any i...

My phone connection keeps dropping so I'm trying to upgrade my SP112 Firmware.Current version is 1.0.2, I downloaded 1.2.1 When I log into the SPA112 as Admin and click on Administration, I don't see an option to perform upgrade.I have peform factory...

I have some Crestron touchscreens that are capable of SIP communication. I would like for them to become extensions in the phone system but I have no idea where to start or if I can make it happen?

At one point there was discussion of providing the OEM BE6K images to the 9.0 market trial participants so we could eval/emulate any changes to the OOB experience in version 9.1.  I know the upgrade images are downloadable and we can take our 9.0 to ...

I'm doing a configuration of a:UC540W-FXO-K9 10 phone SPA301-G1 The problem is that I can not enter the brackets on the CCW does not give me the option, I need to be SharedSupport Apparently these are the part number required for each component CON-S...

I'm doing a configuration of a:UC540W-FXO-K9 10 phone SPA301-G1 The problem is that I can not enter the brackets on the CCW does not give me the option, I need to be SharedSupport Apparently these are the part number required for each component CON-S...

Setting up a UC320 in the UK and it offers two options for the local phone numbers of 6 or 8 digit numbers. The problem is that there are 6, 7 or 8 digit local numbers with 3,4 or 5 digit area codes. Within 20 miles of methere are all three of these ...

Hello, I'm looking to roll back firmware on 6941 (SIP) phones. The BE 3000 provides a list of installed software and the ability to upgrade. We do not see a way to delete the new .cop files so we can roll back. Any ideas or knowledge articles would b...

Hi We are trying to connect an imarsat phone to the FXO port of the SPA 8800 However I seem to be runing into issues with the DID number the number I have from suplier is +870122122890When I try and put this number into the Connections  Seetings Tab ...

I have configured the following dial peers on my UC560. I can call out but when a call comes in, it doesnt get to the analog telephone on the voice port 0/0/0.What am I not doing well?dial-peer voice 1 potsincoming called-number .direct-inward-dialpo...

Dear Support,We are testing new cisco ATAs - SPA112 to replace SPA2102 which is out of sale. We never had fax issues with SPA2102, but now can't get T.38 working on new SPA112. Tried different settings, including recommeded in admin guide (section: "...

FYI, I ran into an issue configuring devices in UPM, specifically LDAP.  I configured the optional section for LDAP, and the Test Access button fails.  Checked all settings, tried different settings, but not change.  I decided to try the LDAP configu...

Hello,       I am wondering if there is any chance to configure on a UC320W a DYNDNS.ORG address.       In menu there is absolutely nothing about it. But is there any way (or will it be) to configure it?Thanks for your time.Manel.