My Linksys SPA400 has been accidentially powered off while firmware update. After restoring power supply device does not get ip from DHCP server. "Power" LED is on. "Status" LED is off. All four "Line" LEDs blink once in four seconds simultaneously. ...
Thought 1: Everything I've seen regarding the initial CCA-driven configuration of a UC520 says to:connect a PC (with a DHCP directly up to any switch port on the UC520fire up CCAtell CCA to 'add a new customer site', specifying IP address 192.168.10...
Hi, I´m trying to configure a Cisco CP-8851, it´s supposed to be resset to factory settings, I´ve performed the resset holding # key and presing the secuence 123456789*0# and it seems to be with the factory default settings, but when I try to configu...
Phone not working even after factory reset. Mute light in red is on cant be turned off. Cant call out or received calls Can you advise?
Hi guys,Can a Cisco ATA191 transmit DTMF at RFC2833. Need to find out before I recommend this a solution for a client.Client has automated access company currently operating on an analogue phone line with dial up modem to talk to the door systems. If...
Hi, On my Cisco IP Phone 8841, I've configured an XML Directory Service and set the "Reverse Phone Lookup Serv" setting to "Yes". Using phone UI, I can access the directory. However, when an incoming call arrives, no lookup is made by the phone...
Hey All,I am a newly system admin for a smaller business, and currently learning the cisco phone system (CUCM). We have a line group where the numbers need to be changed regularly, and I am wondering if it is possible to allow specific users to do th...
Good morning,I need your help. When I enter the phone's IP address it asks me for Login\Password.Is there any way to recover Login\Password to access the web interface? The previous employee left without leaving any information about his workstation....
Hi,We have three numbers of 7942G IP Phones with IP numbers 192.168.2.107/112/115. Now i want to make call between these phones with IP address. I am unable to make call with IP address. Can you help all the settings.thx
Hey everyone! I've got 5-6 Cisco IP Phone 303 models that support 3 lines. 3 phones share one extension (301, front desk), and two phones in the back office each have their own extension (302 & 402). What I'd like to know is whether these phones supp...
I have :1) Cisco CP-8851-K9 IP2) 2921 router with VIC2-4FX0 card3) catalyst 2960-s series switch Any one who can give me connection topology and configuration for VOIP service.
Hi, Does anyone know if the following Cisco CTI is still available and supported?"Cisco Unified CallConnector for Salesforce.com"Thank you
I want to upgrade the used cp-8811-3pcc model firmware.However, if you try to download it from the website, you cannot download it because this error appears.I've tried changing my browser using Safari, Chrome and even Internet Explorer but I still ...
Hi we have installed an ATA191 (client had an old SPA112) to work with a new BT VOIP system that we recently installed as they need a bell to ring if the phone rings as it's so noisy. Can't get it to work. Any suggestions. Do I need an ATA192 instead...
On a previous phone to find/call a contact , all I had to do was use the numerical keys with corresponding letters. eg. for Gary, I would press 427 and would get suggestions from my contact list. Charlie would be 242 etc. Does anyone know if there is...
