Hi All,As per the subject heading, if I was to put a cordless DECT phone into the FXS on the UC320, is there a way to transfer calls between other FXS based phones?Cheers,David.
Does anyone know when the next version of UC500 series software will be released? I'm assuming it will be 8.1.5 or 8.2.0 .It has been almost 5 months since the release of 8.1.0.Thanks!-BrianComputer Repair NJ
There are a few issues with the web interface for the uc300w that I wanted to ask about and possbily get a resolution.1) When logging in, if you press tab between the username and password, it goes to the address bar and you have to click on the pass...
70 entries have been loaded to external directory of SPA303 via yellow page of UC320. User can press "dir" button --> 3 (corporate directory) --> 2 (external directory) and dial the number (1~70) to make the phone call.However, the phone will be no r...
We have two clients both using the UC540 with nexVortex SIP Trunking and they are unable to call each other but can make and receive calls to anyone or anywhere else with any issues. Does anyone have any idea's on where the problem is. We have been o...
I have been using linksys PAP2 Device from last 4 years and I am really satisfied with its performance, but when I ordered SPA8000 for connecting 8 SIP Clients my life became miserable. I am using SPA 8000 as 8 SIP Clients directly connected to Aster...
Good afternoon, ladies and gentlemen.I have configured two SPA8800 forwarding to 4 telephone lines, but when you call onone line to the FSO then after 60 seconds if no one is not picked up the precipice is SIPsession but sirens are calling from. Belo...
I'm registered with a SIP provider using my SPA303 but I'm unable to make calls. I've got phones that work with this provider and the SIP trace shows that the INVITE string uses tel: instead of sip: and for another phone, it has an option called "Use...
I have three Cisco WIP310 IP phones that I wish to use on our corporate network that supports SIP. I have successfully attached one of the phones to the wireless network and configured SIP and the phone works great.However the other two phones have a...
Hiplanning to do a UC560 factory restore and reinstall using CCA3.0 on a week day. customer doesn't want the down time. so planned to divert the incoming calls to a mobile no while completing the task. will it work. i know we can't do any testing dia...
Hi,Is there anyone who can walk me through the programming to have the 3102 and the 2102 be aech others sip proxy without registration?The application is an analog extension from phone system A, going through a 3102 and extending through the Internet...
How do you setup a UC540 to VPN with an SA-520 all having Public Static IPs. Will the VLAN100 and VLAN1 pass through? Do I need special setup to allow SPA509 phones to work at the remote site where the SA-520 is installed?
When I received my sidecars for the phones with the added buttons I was suprised that they were the old paper style. On my Response Point system we had LCDs for the sidecars.I would like to add this as a feature request at some point in the future. ...
I would like to suggest an option in the system that would allow me to forward voicemails to email, and automatically delete them from the VM systems. Now I get the VM in email, and have to manually do cleanup on the phones of all the messages I hav...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
