Voice Systems and Accessories - Small Business

I have found a problem with the 7.1.3 Early Adopter pack. I discovered that the firmware for the 7940 and 7960 phones are missing from the 7.1.3 Early Adopter pack. However, I was able to copy the correct phone loads for the 7940 and 7960 phones from...

we are creating a localized manual regarding the spa525g, it came to my attention that it seems to be impossible to edit entries in the personal phonebookdo we have to enable something for this to be possible, or is this a feature missing on the spa5...

Hi,The following is the current dialplan on spa3102.L:20,S:7,(4163067274|9058861310|9058899296|(*xx<:@gw0>|[3469]11S0<:@gw0>|[2-9]xx[2-9]xxxxxxS0<:@gw0>|1[2-9]xx[2-9]xxxxxxS0<:@gw0>|011xx.<:@gw0>)I understand that if my sip registration is gone or po...

Hi,I am proposing a solution for a customer that requires 2 internet connections to provide 1 connection purely for SIP tunking (Voice) and 1 for general internet use, my question is can we deploy 2 internet connection to the UC520?

I have been searching through my show run config and cannot find anywhere these services are located. I am unable to get rid of these two services from my CME Service URLs and do not wish to see them. Does anyone know if this is possible? If so what ...

We are trying to setup an analog phone outside in the lobby that when the handset goes offhook it will ring a line tied to an ephone-dn on the receptionist phone - anyone have experience with this?  Ideas on what kind of phone we need in the lobby an...

By default, is SIP disabled on outside interface?Ie.  could someone connect via SIP and make calls?I remember some technote came out says it was enabled by default on routers.https://supportforums.cisco.com/docs/DOC-3031

I did have onramp faxing working...now after upgrade, it no longer works.Anyone have any suggestions?Update - CCA 2.1 deleted the on- & off-ramp apps.Update2 - The old command was:application service onramp flash:app_faxmail_onramp.2.0.1.3.tclBut it'...

I'd like to change the LAN IP address of a UC520 without going through the voice wizard.I found the instructions that Marcos posted here, https://www.myciscocommunity.com/message/7677#7677. This should work, but the IP address I want to use is on the...

We are setting up a 48U with a SIP trunk.  Is there any way to configure more than 14 callerid outgoing translations?  If we select more than 14 "Use DID PSTN Number" through CCA then we get the error that Only 14 Translations are available.    Users...

We are planning an ACD call flow that will create a series of queues, and if no agents are logged in or if they are tired of wating they can break out to two seperate general delivery mailboxes and then light the MWI indicator on any phone that we as...

We have some shared line appearances on 4 phones. We have a new phone number we want pointed at Ext 101. I take the shared line appearances of Ext 101 off of the other three phones Ext 100,103 and 105. When the phone number of 499-1251 is dialed it s...