VPN

Hello all, I'm hoping to get some feedback on a scenerio, that I'm unsure is possible given certain parameters:We are looking into putting a remote site in place that at this time, can not have any major wan connection (MPLS, T1+, ect) but must rely ...

Hello everyone,I'm struggeling to get a DMVPN to work over an IPv6 WAN Network. I have testet IPv6 connectivity from the Spoke (2001:2:2:2::1/64) to the Hub (2001:1:1:1::1/64) which is successful, there is also an IPv6 default route to my "ISP", I al...

Greetings to the CommunityI am trying to figure out a clean solution for the following scenario. I have my PIX 515E (8.0(4)24) configured for VPN access. In the VPN configuration, I am using an RA tunnel group configured to use Windows 2003 IAS to au...

Hi allcan anyone tell me how the vpn filter works on the ASA, Also I have ticked the box that says bypass interface access lists, however the inside to outside access list on my interface is blocking the vpn traffic going out. I thought the tick box ...

Trying to keep what seems like a convoluted problem fairly simple.For this particular problem, I have 4 interfaces on the ASA 5510 (untrust, trust, prod, dmz), 3 subnets and a single VPN network.VPN network = 10.1.55.0trust interface = 192.168.1.0pro...

Hi!I have a  question regarding certificate-handling in the ASA (for example for  using it for AnyConnect).I'm not talking of the internal CA  here, just about handling certificates coming from an external CA.If  you configure a trustpoint on the ASA...

Hi everyone,I've been digging around the forum and haven't found a solution to my issue.I configured an old 1711 router for a home office setup while waiting for Skydrive. They have a fairly old cable modem only capable of forwarding tcp/1723 for PPT...

I can't seem to find any clear documentation on this. I can find documents on mapping users to a group policy based on AD group membership. I'm simply wanting to put all our VPN users into an Active Directory Group and only these users can authentica...

Hi everybody,I'm using ASA 5510 I have two inside interfaces my endoutside:  a.a.a.ainside1 : b.b.b.b/24inside2 : c.c.c.c/24other end outside: d.d.d.dinside : e.e.e.e/29There is tunnel established between b.b.b.b/24 and e.e.e.e/29I'd like to route th...

I've setup a S2S IPSEC VPN and I'd like to check the actual speed I am getting betwen the 2 endpoints. How can I check my actual tunnel speed?Thanks

Hi all,I have installed a SSL certificate for ssl/anyconnect VPNS onto my asa, my cert is named vpn.domain.co.uk but the device is named webasa.domain.co.ukwhen i browse to the site using chrome i get "you attempted to reach vpn.domain.co.uk but inst...

Hello All,Sorry for the newbie question. I am brand new to cisco and have configured my ASA 5505 completely with ASDM.Can anyone tell me how to allow traffic on a specific port thru an ipsec point-to-point VPN? I need to pass packets on port 53256 ov...

Cisco Adaptive Security Appliance Software Version 9.0(2)Device Manager Version 7.1(2)I need to set up AnyConnect so that remote users using Windows PCs can easily download/provision the AnyConnect client, enroll using SCEP to get their certificate a...