VPN

Hi,I have a ASA 5505 VPN Concentrator using ADSM 5.2 connecting to a BEFSX41 router.  Its a pretty simple set up that has been working for years.  However, over the past several weeks the VPN tunnel is consistently dropping every day or two, however ...

Hi Guys,I have configured a Cisco 881 with a remote acccess ipsec vpn. The VPN authentication works fine, and connects fine.once connected i can see the route is available, split tunneling is working and i can ping the Vlan interface on the router, h...

Users are getting a Certificate validation error when trying to connect  to vpn through the Cisco anyconnect client. We have them delete the  profiles folder in the c: drive on the users laptops and they can connect fine. They could  delete the folde...

Hello, everyone!Got  one ASA 5520, with one outside and one inside interfaces. Users from  inside can access internet through NAT. I have remote access vpn users,  who connect to outside interface and can access Internet through that  interface (no s...

helloi just configued a L2L tunnel between ASA 5510 and ASR 1004. tunnel is up but got serious packet lost (more than 70%)and isakmp always up-down intermittently.i compared parameters on both sides again and again but no luck.here is simple diagram ...

I am using anyconnect 2.5.2019.  I am getting the following message when connecting from multiple win7 machines. 'anyconnect was not able toestablish a connection to the specified secure gateway.  please try again'.I am getting vpnui event messages w...

Dear all,I have a HQ with two branches, the HQ contains one 3900 ISR router with two WAN connections, the two branche sites each one contains one 2900 ISR wth two WAN connections for each router.i need to establish a site to site vpn with GRE between...

Hi,I am configuring the  ipsec site to site vpn it is in ipv6 i am able to configure the all vpn configuration but when i give the match address <accesslist-name>for intrested traffic It is giving error already access-list exist but i dont have any o...

Hi all,I need some info for my understanding. I have setup a IPSEC site2site tunnel for management. Tunnel is up and I can access the remote site management interface and all devices that connected to the mgt. network. That fine for me. Now my proble...

HiI need to route traffic to DMZ (and internal) from the branch office thru the IPSec tunnel. How do I manage that with my Cisco 881?IP: is just examples

I've followed Watchguard's instructions for configuring a Branch Office VPN connection, and I'm unable to connect.  I have configured the Watchguard gateway to accept remote-to-local connections and put in the Watchguard's public IP address as the lo...

Due to the recent security issue with AnyConnect 2.5.2019, the ASA pushed AnyConnect 2.5.3041 to the all of the Windows and Mac computers. After the upgrade, some of the Mac OS X computers can't establish a VPN session when using the new client. Down...