VPN

Hi,Does anyone have any reasons why a 2811 should _not_ be used as both a low traffic (5-15 concurrent calls max) SIP/PRI gateway and a VPN gateway (for about 10 VPNs, up to 5mbps traffic total) at the same time?768megs of ram, adv ip services 12.4(2...

I'm having an issue terminating L2L vpn and I think it's due to the fact I have multiple vlan's on my asa.  We have a 3750 that has the ISP WAN interface, the ASA External and Internal NIC's attached.  We also have our Internal VLAN's on the 3750.  T...

I am trying to use WebVpn to do the following:-1. Remote Desktop - How do I get the printers my users have on their local machines mapped across so they can be used in the Remote Desktop. By connecting using th eCisco VPN Client it works, so there mu...

I currently have 2 sites, both connected to each other through 2 firewalls / routers in a site-to-site VPN. Pinging from server to server (Using 2mb/2mb SDSL) through that VPN obviously works, however, at one site, we have another internet connection...

I'm looking for documentation for whether if GETVPN supports Firewall NAT'ing. found a link where port 848 some what addresses GETVPN firewall NAT'ing, but it's limited:http://www.cisco.com/en/US/docs/ios/sec_secure_connectivity/configuration/guide/s...

We have an environment with about 120 STS VPN sites.  Each site terminates IPSec on an ipsecdist router that is in a DMZ.  Each site also terminates a GRE tunnel on a vpndist router that is on our trusted network.  Currently, QoS is applied outbound ...

I am having a vexing issue.  I have a PIX 525 with PIXOS 8.04.  I have setup an IPSec VPN group and the client can connect to VPN just fine with the Cisco VPN client.  Yet, when they try to access an internal resource in one of the DMZs, they are una...

I want to be able to connect to asa via portal page from any internet location, automatically use anyconnect (no user choice), and have all networks tunneled (access to both the internal 192.168.5.x lan as well as that sites internet connection).  Wh...

Hi There,We are using the ASA5550 for the client VPN implementation with IAS as the authentication server (Windows AD user accounts). Now, if we wish to have a user connect to our VPN who is a vendor and does not need whole lot of abilities to browse...

Hi VPN Group,I've at least one user who works from home a fair amount, has a new PC with Windows XP, latest service packs and is using the Cisco VPN 5.x client to connect to our VPN 3000 concentrator. The user's home network is using the 192 IP schem...

Hi, i have a problem. I've connected my ASA appliance to an ADSL modem, and i dont get an DHCP address on the outside interface (e0/0). I use the asa-722-19.bin firmware. I turned on the debugging for the DHCP client and could see that the ASA devic...

The AnyConnect client is working great for Windows Remote Desktop Connection, except when used from behind a Linksys router on a home network.  I have read some configuration suggestions for the Linksys but nothing has worked.  The AnyConnect client ...

Hellocan we terminate Site-to-site VPN between ASA and Juniper?Thanks