VPN

I have a 3845 and a 2821 router. I want to configure a router-to-router VPN as a backup to the WAN connect. If the WAN goes down the VPN on the 2821 will kick in and establish a connection to the 3845. I am using EIGRP and BGP on the network. Routin...

hello!i recently configured on a cisco asa 5520 remote access using ipsec.the remote client uses cisco vpn client.the vpn client successfully authenticats and connects to the asa, however i dont have access to the lan. this is the first time that i c...

Hey Pros!We have an ASA here with two ISP links running directly to it. The ASA provides Lan-to-LAN VPN tunnel services between us and our partner company. The partner company has two separate sites, which we will call Site A and Site B. Our ASA's pr...

I have an ASA5520 running 8.0.4. I need to create a tunnel with a vendor using the same internal network as we are. They are unable NAT on their side. I would like both sides to be able to bring up the tunnel. They are using 10.2.x.x/16 as their ...

I'm finding out VPN bandwidth calculator or any formula to calculate bandwidth related to remote VPN. Let's say, 250 simultaneous/concurrent users connection. What is typical average per conn I think? including voice traffic as well? How much BW i ne...

Dear All,I want to ask abut VPN connection.the both side i used ASA 5510 and 5505 and VPN connection. so the branch it can ping to HQ(i mean the VPN connection is ok) but i want the branch they can use internet from HQ.but know the branch cannot use ...

I'm installing some new ASA 5520's which will be used strictly for VPN connections (both lan-to-lan and client connections).I have some questions about the best way to setup redundancy and failover and integrate it into our network. I've attached a d...

I am having a problem setting up a L2L tunnel with a partner. I am using a ASA 5520 running 8.0.4. Both sides of the tunnel are using the subnet 10.30.x.x/16. The network list on my side of the tunnel will have the nodes 10.0.194.1, 10.0.194.5, 10.0....

How can I setup a VPN between router1 and router2?internet --- Router1 --- 172.16.1.0/24internet --- Router2 --- 59.23.34.0/24

helloam attempting to build a hub and spoke topology using l2tpv3. at the hub CE the virtual interfaces are placed in individual vrfs. this i have tested successfully where the tunnel end points/local interface are routable in the global routing tabl...

Hello;We configured a new VPN tunnel on our VPN concentrator 3005. Local IP address for this tunnel 10.0.0.100/32 and we named this as X_local. There was another network-list names as Y_local which also has 10.0.0.100/32. After we configured the new ...

Hi all,Someone tell me if the ASA can do the reverse proxy?Thank you