VPN

Hi,I have two 2304kbps sync'ed SHDSL Cisco 878's in our lab direct connected to a DSLAM.The maximum data rate that I can reach on the ATM0 interface of each 878 device is as per below 2041kbps, beyond this I get output drops. I am generating 1000B u...

Hello,I have a user that VPN's in and everything works fine. The only thing that does not is another email account he has in outlook. HE can not recieve and send mail from that account. Is there a way to allow this when he VPN's in? vpngroup xxx a...

I got a calling saying a site to site vpn went down at lunch time. here is the output from debug crypto map iskampanyone got any ideas why phase 1 wont establish. apparently the config has not changed004135: Oct 16 15:46:18.252 GMT: ISAKMP:(0): SA ...

How can I configure idle timeout for IPSEC sessions. The configuration only allows for idle timeout for webvpn but I don't see where for IPSEC sessions.

I can not find information on equipments that support for SDM and the Cisco IOS that can be used, someone knows of a link or information?

I have one proxy with two NICs, an with ip 192.168.2.0 and other with ip 192.168.1.0, the default gateway of the proxy is, ip 192.168.2.115 , router of the ISP. I have an router that connect vpn clients ( pool 172.18.0.0 ), i have route in the proxy,...

Good morning, I'm starting to study for take the ccna certification.Could someone tell me the difference between PABX and isdn simulator and it's possible connect two router with wic ISDN by PABX?. I have a PABX with 4 internal ISDN line where are l...

Ok, I thought that I had setup everything I would need for a user to access my network behind a PIX 515e but I guess not.I basically gave inside and outside ports ip adds on their respective subnets. Created some ACL's applied these to a group and g...

Dear Sir,i have PIX configured to allow internal users to access the internet, and to allow external users to access internal FTP, HTTP and emailthe problem is that external users cannot access HTTP and FTPand the mails cannot recievedfrom outsidethi...

HelloWe are trying to establish a VPN tunnel between two Cisco 2821 routers with RSA-nonces authentication. Each test fails. In the debug crypto isakmp we can see the message "%CRYPTO-6-IKMP_CRYPT_FAILURE: IKE (connection id 268435471) unable to decr...

Can I download the Cisco VPN Client? If so where can I get it? I have visited the product center and founf the product. When I try to download it, I keep getting the log in screen and enter my credentials.

Does anyone know if is possible make an SSL VPN with full nework access (ActiveX) between ASA 7.2.2 and windows mobile 2003 or later?

In the past month we have suddenly become unable to receive inbound smtp traffic from a specific client.After some packet capture footwork it appears that whenever the external mail server tries to access our internal mail server via smtp our PIX tre...

I have setup a VPN between and ASA5505 and a PIX 501. It seems as though the VPN is "on demand" meaning if I don't use the connection to the far end private network, the connection dies and is restarted when I try to initiate connectivity back to the...

Hello, I've read the product doc and discussions on this forum, yet every time I have tried to upgrade an ASA from DES (K8) to 3DES/AES (K9) I end up with a K9 license that has downgraded my other licensed features and have to call TAC to get the pro...