VPN

Pls see my PIX version and the Hardware details below:Cisco PIX Firewall Version 6.3(5)Hardware: PIX-525, 256 MB RAM, CPU Pentium III 600 MHzFlash E28F128J3 @ 0x300, 16MBI added a host on the IPsec tunnel, run the following command: FW# sh crypto i...

Has anyone ran into this problem before?I have a 3845 running VPN software that connects to a 3000 connectrator. The problem is that the tunnel drops and when it does that the only way it can be brought back up is if I initate interesting traffic fro...

Hello,I have just purchased a 857. I would like a couple of users to VPN in to access a server on the LAN. What are my options here? I can't seem to find any instructions to do this. Do I need to purchase the Cisco VPN Cleint software or is there any...

My original VPN setting did not properly function accidentally. I paln to remove the original VPN setting from ASDM 5.0 for PIX not from command line and re-setup again by using VPN Wizard.

I am interested in finding out, if I have a tunneled in (established IPSec connection via remote VPN) and then what happens if external interface becomes unavailable? Do I still maintain connection, if I my tunneled gateway is on internal interface?

Hi,It's not clear to me whether it's possible to terminate IPSec on one of the ports of HWIC-4ESW (through VLAN)? The document on the link below suggests that it supports L3 with limitations but it's short in mentioning whether IPsec is one of the li...

We have AS5350XM (see detail in version.txt).After some times when I calling to AS - I receive "BUSY" and debug show me:*Apr 5 17:09:12.306: msg_to_calls_mgmt: msg type CPM_VOICE_CALL_REJ_NO_MOD_AVAIL receivedI reload AS, and 6-8 hours have no any p...

Dear?s,I?m have um failover with the ASA 5510.The tunnel L2L is working! When the primary goes for shutdown, the secondary one is activated, but i have problems in the VPN. The following error occurs: Apr 06 15:27:38 [IKEv1]: IP = 172.19.33.7, Removi...

I have an 871 router configured with a VPN tunnel, but now need it to have internet access. Is this possible with an 871 and how is the traffic kept seperate?

I have a customer using a Netgear WNR834B Draft N router and he is not able to VPN to our office. We use Cisco VPN client 4.0.1 and he is able to use VPN if he uses the internal wireless (a/b/g) card, but not the Netgear PCMCIA Card that is provided ...

I have a pix 501 Ver 6.3(5). Users can connect to the vpn fine and access resources on the inside interface fine. I would like them to be able to access a server that is on the outside interface is this possible? Thanks

I've been trying to use easy vpn do establish a connection between 3 sites. One site has a fixed IP and the others have dynamic IP addresses. I have tried to use the easy vpn wizard (the server is the site with the fixed IP and the other two sites ar...