Hi,I am using a BRI ISDN to connect to remote site BRI ISDN.When use debug isdn q931, the following display:ISDN BR0 Q931: RX <- ALERTING pd = 8 callref = 0xAC Progress Ind i = 0x8282 - Destination address is non-ISDN Is there any solution f...
Hi, We have TACACS enabled in our routers. I wanted to restrict user access to only particular commands. I am providing those commands below. Router#term len 0 Router#sh clock Router#sh ip int br Router#sh env all Router#sh int s0/0 Router#sh int s0/...
Hi,If I've got a Lan to Lan tunnel to a VPN concentrator and part of the tunnel is the network of the PUBLIC interface of the concentrator - will I be able to access that network from the remote end? Or will it not work since that network is on the ...
At work we have got Cisco VPN 3000 concentrator is currently running , I have been assigned to write document about enhancement the VPN security by using TOKEN, I have not been given any further information.I have done an intensive search , but I cou...
I have Cisco 3000 with vpn client. On the remote computer, I can ping across the tunnel to the company servers and ping the router as well as netgear print server. I am using split tunnel with "allow local LAN access" enabled.I am using IP address a...
I have a site to site tunnel built between my support company and another client.When I perform the command "sho ipsec sa" to examine all of the sa's that should be present, I see the following output:"Crypto map tag: map1, local addr. 206.248.224.2"...
Hi,I'm trying to configure three different VPN scenarios at the same on a Cisco 871.The first one is a VPN between two 871 with static IPs.The second one is a VPN between one of these 871 and a non Cisco VPN-Router with dynamic IP.The third scenario ...
Hello,Just set up 2 ASA 5520s in an Active/Passive configuration at our off site hosting facility in order to replace our old Pix firewall. We have an ISA2004 server at our office location which handles our traffic internally.VPN from our office to o...
This is kind of a general question about how CBAC works. If I have the following inspection on my outside (Internet-facing) interface:ip inspect name ASDF icmp router-trafficip inspect name ASDF tcp router-trafficip inspect name ASDF udp router-traf...
All,I have 3 locations at, site A, B & C.Site all 3 locations are connected to each other via a VPN tunnel. However the link between site A and C has gone down. I would like to route all traffic from site C to site A via site B, is it just a case of ...
I've got an question about the e-mail proxy in the ASA 5500.Is it only for the webvpn's or can it also be configured for the cisco vpn Client's?Thanks in advance
Of all the VPN documentation Cisco provides, can anyone point me towards the best to setup Secure VPN clients(4.8) to a Cisco router(1841) for remote connectivity? Our 1841 is also doing site to site VPN, so I cannot disrupt that configuration.
Hello, I´m having two problems with four VPN´s mounted on a PIX 515E connected to the Internet by a direct concection. Other peers are Linksys BEFSX41 with DSL.1) I set up different crypto maps (each one with it´s own isakmp key), associating those k...
Hi All,refer the attached topology and config file for the routers.Requirement is to serve the internet for both the lan subnets as shown in the diagram.Will this config work or is anything else reuqires in terms of interface natting.Regards
I have remote access solution and I am using dialers. As I understand there is limit of number of dilaer interfaces and I am getting close to that limit. What steps should I take? Replace it with waht tecnology? Or can I overcome this limit somehow?t...
