Anyone have any experieance trying to get a cisco 3000 IPSec tunnel to a Linksys befvp41?I've spet a few hours attemping to do this with little success.Wonding if it's worth the effort and if so whats the trick to make them talk.
I'm a total newbie when it comes to cisco routers, I've installed a cisco 836. Adsl with fixed IP.Now I would like to add VPN, for this I have an 1712 I can use.I searched Cisco for example config but couldn't find one.Can anybody give me some genera...
What is the limit on the number of local users that can be configured on a PIX 515E for VPN Authentication? Is there a hard limit or is it memory dependant?
Hi! My Cisco 3620 experiences very high CPU utilization with modest amount of traffic (about 600 kbps) over an ipsec vpn tunnel. The CPU utilization is 98%, and 97% of that is due to interrupts. If I generate more traffic, the router freezes (no resp...
First like to say I'm new to this so bear with me.I've been asked to configure an 837 router to access the Internet and also I need to be able to VPN to this router from our remote 2621. I need the VPN connection to be set to time-out after 30 minut...
We have an PIX 515 and a 2650 router (outside the PIX). We have a few users who VPN to the PIX from home using the Cisco VPN client. We are trying to tighten the ACL on the outside router so we need to allow the necessary traffic to allow the users...
I have a PIX 6.3(1) configured to give access to remote VPN, all is working fine except when I attatch an ACL to the dynamic-map with the command:crypto dynamic-map MAP-NAME 30 match address acl_nameThen the IKE Mode Config cannot assign the IP addre...
One of our staff is relocating to Europe... and we need to give him a VPN that's as fast as possible. Using fast hardware on both ends is the best way to do this, right?Looking at Cisco PIX 506E, but not sure about its compatibility with our Zywall 7...
Hi,We have a customer who has two offices, Office1 and Office2.Office1 and Office2 each have a Cisco PIX 501 connected to a DSL router in half-bridge mode. Each PIX has a live Internet IP address.From home, I can establish a dial-up connection to th...
Hi allJust wondered what everyones opinion on not including sysopt connection permit-ipsec and setting up rules on the outside interface.Is it not a security risk to have these rules on the outside interface? ie could someone spoof the address assig...
I have just recently purchased a 506E PIX and want to use it as our FW and VPN server (one remote and remote clients). Our current 2621 is internet facing and I want to find out what is the best solution for deploying the PIX. Would the best soluti...
I have a PIX 515e at our main location and several 506e's and 501's at remote branch offices (all running 6.3.3). I also have a WebSense server in the main office for URL filtering. The 515e talks to the WebSense server on the inside interface no p...
Hi All,We are trying to make a vpn connection with a Cisco vpn client from a workstation within our network through our 515E to a remote network also protected by a cisco firewall. When we start the vpn client the connection gets build ok but we get ...
i've got a point to point VPN connection set up between a PIX 515E and a Cisco 1720 Router.. the link is mainly used to run a few SSH session between the sites. My issue is, that if these SSH sessions are left idle for several minuits they will be ...
