VPN

Does any have experience with configuring an IPSEC tunnel with NAT? My current configuration has an MCU server on the back side of one router with a nonroutable address. The clients are able to dial into the MCU from from one end of the tunnel but...

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...

I have an 827 that establishes a vpn tunnel with a pix506e. I want to be able to set up a floating static route on the 827 incase the adsl link goes down I can route it through alternate means. I have a router on the inside of the 506e that needs to...

Is there a way to make this work. I have a PIX at site A with a DMZ interface. I want site B to get to site A inside and dmz resources. I've tried nat 0 allowing the extended network at B to get to the DMZ without natting. That didn't work. I haven't...

Hi i m trying to establish a IPSEC tunnel between a router and checkpoint F/W.I hve already 12 locations running with the same setup establishing tunnel with the F/W.all the locations r having same H/W(1751) same IOS.At present i m facing some probs...

We have the following VPN Scenario:One the Gateway side, we have configured a PIX 506 firewall as a VPN server, with preshared keys. The client PC is a Windows 2000 based computer. This computer is connected to the Internet through SBC DSL connection...

How should I tackle the security issue of home users having VPN clients?Is there any white papers that deal with this issue?Thanks in advance

Our company is looking at purchasing a FWSM and VPN module for each of our 6509's (as VPN support was removed from the FWSM). I have researched into this configuration and noticed that originally the FWSM and VPN blades were not supported in the same...

This is kind of a wierd situation. we have a hardware monitored firewall. one of our offices has requested a VPN be created to connect there firewall and ours. Now my question is this they have to contact us to setup ourside of the connection of the ...

I have a main network 172.16.9.0/24 and a remote network 172.16.2.0/24. The remote network is operating in NEM via a 3002 hardware client with VPN 3015 concentrator as headend device. The hardware client acts as dhcp to just the .2 subnetwork. A 2600...

Is there a way to configure PPTP VPN over PPPoE DSL connection on PIX501 ?a cisco tech engineer says it is possible on pix, but no reference/docs are available.actually cisco docs say it is NOT possible on pix 6.2. see:http://www.cisco.com/en/US/prod...

Hi,I'm running a IOS based VPN router and have successfully configured a VPN client toconnect to the router.However, I am not able to advertise the client's network into the EIGRP routing domain.Just wondering if anyone could help with this.Thanks,Pa...

Hi All,I'm trying to configure a IPSec Tunnel Between Windows 2000 & PIX 6.3 since last week. Am following cisco document http://www.cisco.com/warp/public/707/2000.html#tpix and it just doesn't work. On the PIX debug crypto isakmp doesn't return anyt...

Is there a way to compress traffic inside a PIX-to-PIX VPN?I found that the VAC is also a compression card, but what happens if my VPN is between a 515 and a 506?Thanks Stefano

With a variety of ADSL/ISDN connections and 800/1600 routers connecting back to a 3015 VPN concentrator we appear to be experiencing difficulty with Novell servers on these sites. Groupwise MTA's seem to be erratic and not communicating, RCONJ connec...