Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
I have a WLC 5508 running 8.5.120 code. I have wireless client who need to print from Apple devices to a HP M426 laserjet printer. So I set up the WLC for mDNS by doing the following:1. Enabling mDNS snooping2. Enabling global multicast and IGMP snoo...
I currently have 2 Cisco 1831i Ap's and one is configured running my store. I can access it but am having issues updating it to the latest firmware to try and address an issue where the Primary AP will allow the Subordinate AP to connect and pull co...
Hello, we have a 1532e outdoor AP with 8.5.140.0 running controlled by a 5520 WLC. With 5GHz and 2,4 GHz enabled and up. After a few minutes, no 5GHz client can connect to the AP. When we restart the AP, clients can connect for a while. The antennas ...
Dear Friends, How are you all.I need help to to plan best wifi coverage so need AP plotting on floor plan. can anyone help me in thise please inbox me.
My controller is AIR-CT3504, software version is 8.5.131.0. I have such a problem, the manage port of my controller and all the AP are in VLAN99, all computers are in VLAN172. I could access WLC manage web from LAN cable of VLAN172 before I enable Co...
I Have 2 5520 WLCs working as active and standby. Every hour or a half of hour i hearing a huge noise from FAN although they still working fine.IOS Software : 8.3.143 Thank you
I am trying to find the OID for the wlc temperature for the following model wlc: 3504550855205810I am trying to create alerts in SolarWinds for high temperature, but having a hard time finding the OID.
I am looking to know all the functionality of the splash page config for cisco. Meraki has a page like https://documenter.getpostman.com/view/897512/meraki-dashboard-api/2To9xm?version=latest#79612cda-002c-45fb-9f88-6e3651b780ab Does cisco have some...
Hi AllI have set up my foreign and anchor WLC, however for some reason im not getting any DHCP addresses from my anchor controller even though the scope is setup etc.any ideas why not ?cheersCarl
Maybe these days somebody struggles the same way like I did last week. So if you want to use the embedded 9800 WLC (often called eWLC) on a catalyst 9300 switch. You have to download the special releases from this site: https://www.cisco.com/c/en/us/...
We are replacing this appliance and I want to clean all our specific information off of the appliance. Restore it back to factory defaults.I tried the "application reset-config" command, but that tell my it's not valid in this version NCS?How can I ...
Good day. After raising the vWLC firmware version from 8.1.120 to 8.5.131, some points stopped connecting to the controller, the log shows (AIR-LAP1141N-E-K9) is unsupported, tell me what to do?
Two AP that act as a controller have the same configuration? -system name IP management:- IP/mask/default gateway-SSID thnks
Is this because the difference about WPA2-PSK Security and Mac Filtering Security ? it can say that its the weakness of Mac Filtering Security, this is below the scenario test I have tested that with this scenario my mobile phone connect to SSID A i...
