My AP's sit outside the firewall and the ACS sits inside. What port(s) are needed between the AP and ACS to be allowed through the firewall (PIX) for authentication/communication to happen? This is using WPA/TKIP with LEAP.Thanks!
I recently installed a Cisco router with a Cisco switch and a Cisco Wireless Controller 2500 with 2 access points at one of our customers.
The router was configured by the ISP and the company that our customer belongs to. The customer also has a serv...
After a solid year of running great one of my Aironet 1142N access points started acting up on me. Yesterday, both radio interfaces changed to 'reset/down' state for some reason. The only way I could get them back to 'up/up' was to reload the access ...
We are trying to deploy an HA setup with our 5508 controllers. I read somewhere that we can do this with VSS cores. My question is exactly how should I connect the primary and HA controllers RP to the VSS cores?
Currently right now all vlans are bei...
Hello Guys
I have a Cisco AP 1602 and have two SSIDs, one for the corporate network and the second one for the guest network.
Users claim that the guest wifi is slow, but while connecting to the corporate one, internet is fine.
Any suggestions?
Tha...
Few logs on the WLC
*apfMsConnTask_5: Feb 17 15:35:28.416: #APF-3-NO_FRAMED_IP_ADDRESS: [PA] apf_radius.c:2066 'AcctInterim' clt MAC: 04:e5:36:00:a1:04 AP MAC: 1c:de:a7:c5:d5:40 Role 'Export Foreign' PemState 'RUN' SSID '*************' Connected for ...
Hi,
I am trying to add multiple SSID from GUI (Cisco Aironet Access Point) on different vlans, when I selecting the interface 1-802.11A in SSID Manager it is giving me error Vlan 3 does't exist on Radio 1-802.11A and it is happening on my Guest SSID...
During the startup I clicked "presence" and wanted to hit "location." Is there a command to restart that setup so the GUI gets populated with the location info instead? I can't find the setup in the web interface to do it. thanks -
Hi All,
I'm hoping someone can help with an issue we currently have. Possibly with mobility in our Wireless system. We are running WLC5508's in two seperate locations, if one fails all APs associated to it should fail over to the alternate. Software...
Dears,kindly i have minor Alert at prime infrastructure 2.0 (Audit done at '2013-nov-28,05:00:00 CET'..config difference found between NCS and Controller),what this error and please feed me back with steps to solve this problem.Thanks,
Cisco 5760 Wireless LAN Controller support the below or not :-
1)The controller shall automatically recognize the type (eg. Apple iOS, Android,Blackberry) and model (eg. iPhone, iPad) of the mobile device connecting to thewireless network without the...
