Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi we have AP1130 all these days it is working but today it laptop was connecting when logged in to wireless I found Radio0-not installed Radio1-not installed. apparently it went in to repeater mode. can any one help me pn thisThanksSP
HiI have one of our clients using the wireless network with a high consumption of data. It has categorised this as Non-TCP Web Traffic, is there anyway I can find out what this is?
Hi, It is not clear to me how many access points are supported in a converged access mobility setup using 3650 and or 3850 switches. The numbers I find, 25 for the 3650 and 50 for the 3850, are these valid in any mobility mode (MC, MC+MA, MA) the swi...
Hello, we have some APs AIR-AP1852E-E-K9, they have the firmware 8.2.141.0. The last AP we got, had the firmware -version 8.4.100.0. i have downgraded to 8.2.141.0, so that AP joined to the primary Controller. The backup image is now 8.4.100.0. cis...
Hello all! I have a problem with users which are connected to our customer Wi-Fi network. When I do ping to IP address of WLC, wirless gateway or LAN DATACENETR or Google DNS I see that 15% of packets are dropped and sometimes ping is around 1-2289...
Hi Everyone, I am implementating wlc 2504 and 1520 ap,i installated wlc and ap are got registered. In WLC i changed parameter as RAP and MAP. As per doucment i have to enable Zero touch configuration in bridging. But bridging option is not their ...
Dear,it`s possible make an SSID based on MAC adress access control with meraki radius log in?.i try to make this by the meraki administration and i´m not allowed. Regards!
hi all, i've got a WLC 2504 that has 5 AP support by default. we purchased for 25 AP license and was successfully to TFTP the .lic file using 3CDaemon. i followed the steps using below but the new license didn't take effect. http://www.cisco.com/c/en...
Hi Team , I have an HP Printer ( which doesn't have a network interface) which I have connected to Mac Book via USB. When I am connected to my Wifi network , I can not see the printer in other Mac Book. However , if I connect both MacBook to m...
Hi I have seen that we can change the antenna diversity on WLC to left or right but dont know how access points would behaves after it? Could anyone help me out? Regards Vikas Vashishtha
Hello,Is it possible to authenticate an AIR-CAP with CA certificate at the switchport, so that the accesspoint do not need dot1X credentials?Unfortunately I can not find a configuration guide or example.Thanks in advance Alex
I have cisco 1700 AP. It was previously on Controller mode. Then, i changed it to standalone mode. Now, i am experiencing various problems. 1.I can't get the GUI access of AP though i can ping the ip of the AP. 2. AP doesn't broadcast the SSID. what ...
Hi Expert,we have WLC 5508 with using firmware version 7.6.130.0 and AP connected to WLC is AIR-LAP1242G-E-K9 series. recently we buy AP 2800 Series. the problem is AP 2800 Series not compatible with os 7.6.130.0. is possible AP 1242G running with A...
Hi All I just realized that 8.5.120.0 has been released. Release notes: https://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn85mr2.html What surprised me though, there is no upgrade path for 8.2 and older. Is this missing in t...
