Wireless

Hi All I just took an old, never used 2012 manufactured AP 3502i-E out of the box (it had image 7.0.114.40 (or something like this) preinstalled) and was unable to join it to any of my controllers. It's unable to build the DTLS connection to the cont...

Hi All I have a problematic AP 3502i here, which doesn't want to connect to any of my controllers. It's around 2 years old and I never used it before (see https://supportforums.cisco.com/discussion/13205991/lightweight-ap-3500-fail-join-capwaplwapp)....

Good morning, Setup: WLC 5508, multiple AP1602 and AP1702, Prime 3.0, HP ThinClients We have clients who are jumping between access points which causes losing the connection. Here is an example from out Prime: When I try to check the signal in this a...

Hi, I would like to ask if anyone knows how to redirect to web authentication external captive portal when the user tries to access HTTPS page. Because I have tested that the user can be redirected to captive portal only when access to HTTP webpage. ...

Fellow mobility engineers, Can I have two controllers running different code (7.6 and 8.x) in a mobility group?  I have some AP's that need new code and my customer doesn't want to upgrade from 7.6.  However, they have another controller with 8.x in ...

Hi all, Im facing a strange issue with IPAD trying to connect AP 2600 with 15.2(4)JB6  IOS, the device connects to the AP, gets the IP address, but does not show wifi sign  and so internet does not work. Android devices or Laptops dont have any issue...

Will someone please explain or link me to documentation explaining the available log modules in CPI 3.1?  #1 I'm sure I don't need every module enabled.  #2 After downloading the logs I don't have a clue where to look. The same scenario happens two, ...

Hi, We have a pair of 8500 WLC's in a HA SSO configuration that is working well at the moment, primary WLC has 50+ APs connected  and secondary was a hot-standby WLC. However we are trying to change the MGMT address. I am trying to find a way not to ...

I have told from distribution that ANT2544V4M-R= antenna  is end of life but i wasn't aware of it.  Is ANT2544V4M-R= antenna end of life? If it is end life what is the replacement Antenna? Thanks, Kumaran

Hi There, We have a 2504 WLC and 5 AIR-LAP1041N-A-K9 access points. Users complain that they lose internet connectivity randomly for a couple of minutes and connects back again. The WLC has firmware 8.0.133.0. I'm going to upgrade it to 8.2.x.x and s...

Hi, I see the RSSI and ED/TI Threshold on show 802.11a/b command, like this on WLC 5508: (Cisco Controller) show>802.11a [...]RSSI Threshold................................... -80TI Threshold..................................... -50(Cisco Controller)...

Hello, I would like to use an AIR-AP1832I-E-K9 to perform surveys. It must therefore operate autonomously so that my computer can connect to it without the antenna being registered on a controller. I tried the "mobility express mode" and the "lightwe...